builder77

I recently found out that the injector line going into the IP was leaking. I can only assume that the ferrule is leaking. It appears that most just replace the line, but me being me I went out and found ferrules. Whether this all works or not I found a good diesel shop in the area. It appears that replacing ferrules is quite easy and normal. All that needs to be done is carefully removed the old ferrule without damaging the line. Use a drill to make sure the inside line size is the correct size. Clean the entire thing including blowing out the inside of the line. Place the ferrule on the line. To crimp it you bottom the injector line out into the IP, and then just tighten it down. It will take care of itself.

I did not get a part number on these, as they were free. The line when I asked how much was it would be more work to look up the part number, so I shut up. If this works though I will get the numbers, and perhaps buy a supply for others.

At the same time I also picked up some of the injector copper washers. The ones used for the ENDT 673 Mack looked just fine. AMGeneral suggested the application.

Attached Images

	img_0349_546.jpg (187.0 KB, 619 views)