FreightTrain

There is nothing wrong with the axles.If a ring and pinion was scattered it would not have rolled with drive shaft out.Chunks would have locked up the carrier and spiders and you would have known.Might ahve made it a little ways but sooner or later something would have hung unless your one lucky SOB....and in that case buy a loto ticket.If the yoke is not against the transmission then you have a scattered tranny.The main shaft is broke.Buy another tranny and scrap the old one.If it broke bad enough to push the output shaft out the rear then there is a very good chance that it was a spectacular failure and looks like you drop a Frag grenade in the case.And I would also look into buying a transfer case too.Cause if the trans blew and now it won't even roll then that truck more than likely was in motion and came to a sudden stop with the tranny acting as teh brake.The transfer more than likely was damaged.Check all the drive shafts and make sure non got twisted.I figure the axles could take such a beating once or twice.You should be ok there.The drive shaft would have flexed enough to take some of the shock load out.You can replace the tranny and transfer for about 300-400 bucks if you shop around and find someone like wreckerman on here parting out trucks....