zout

Got up this morning and made sure I had all my fingers still in tact after last night - good to go after applying a little burn cream to area's -safety is only for working on the truck anyhow.
Flooring in - screwed down - caulked with the silopreme "white" as this will flow into the seams great and harden - then apply whatever it takes to top it off.
Used the 1/2 in impact with a 1/4 in tip drive for the torx headed floor screws - you have to pre-drill 1/4 in holes for these and they will self tap themselves and pull the flooring down tight. These were terrific for the edges of the box - where I mentioned it had deterioated - pulled the angle iron up tight - did lay beads of silopreme on top of all the crossmembers and edges before installing this heavy 19 layer - you can see it is almost even with the wheel wells. The reason it is not even in a couple area - the wheel wells were bent - these have an 1" lip on them and I will use seperate screws to pull these up to the flooring - also countersunk.
Here are the pics

Attached Images

	july 5 flooring 001.jpg (34.1 KB, 176 views)
	july 5 flooring 003.jpg (31.6 KB, 164 views)
	july 5 flooring 005.jpg (18.8 KB, 161 views)
	july 5 flooring 007.jpg (18.9 KB, 157 views)
	july 5 flooring 009.jpg (21.7 KB, 157 views)
	july 5 flooring 011.JPG (22.7 KB, 155 views)