I need to rebuild my m37 t-case
Where is the best place to get a rebuild kit for the t-case?
__________________
SON OF A B/TCH TOOL: Any handy tool that you grab and throw across the garage while yelling 'Son of a bltch' at the top of your lungs. It is also, most often, the next tool that you will need.
An appeaser is one who feeds a crocodile - hoping it will eat him last.
- Winston Churchill
If it walks out of the refrigerator, just let it go…
[Westech] 19:40: you try smacking it with a hammer?[Westech] 19:44: I tell ya it works!
__________________
USNR Seabees 92-04
1953 M-37
1971 AM General M813A1
1970 AM General M35A2 W/W
1995 AM General M35A3 W/W
5 M-101A2's
2 M-105A2's
MVPA# 12227
Unless you run them out of oil they are darn near indestructible.
I've seen them streatched (would-up) so bad from plowing snow in 4WD on city streets that they needed replaced.
You haven't been plowing snow down there have you?
lol no snow here. it just leaking really badly and noisy so i figured it needed a rebuild tho i would much rather just reseal it (it would hurt the wallet less)
__________________
SON OF A B/TCH TOOL: Any handy tool that you grab and throw across the garage while yelling 'Son of a bltch' at the top of your lungs. It is also, most often, the next tool that you will need.
An appeaser is one who feeds a crocodile - hoping it will eat him last.
- Winston Churchill
If it walks out of the refrigerator, just let it go…
[Westech] 19:40: you try smacking it with a hammer?[Westech] 19:44: I tell ya it works!
I say this half tongue in cheek but as loud as those old 200 cases are if you've got a seal out it could be letting out noise with the lub. Is ther a chance you got something (like saw grass) wrapped around the drive shaft/s and it took out a seal?
Unless it's been ranning in 4WD on hard surface or has been ran out of oil it just doesn't sound realistic that it is dieing. Unless it's jumping out of gear there may not be much wrong with it.
I remember one time several years ago a rear end heated up in a Suzuki Sidekick that I had. I automatically figured if a seal was out of it it was caused by a bearing problem. It wasn't. The seal problem was caused by grass. We put a new seal and 80-90 in it and it was still going strong several years later when I traded the car off.
Hopefully all you need is a seal and some ear plugs
i never resealed it when i got the truck, it had good oil in it so i didn't fix what wasn't broke.
so i think the seals are bad because of age. i have it out if the truck and it all seems tight and it turns freely and it never jumps out of gear.
think i could get away with just seals? the noise is just a loud hummm at 50mph
__________________
SON OF A B/TCH TOOL: Any handy tool that you grab and throw across the garage while yelling 'Son of a bltch' at the top of your lungs. It is also, most often, the next tool that you will need.
An appeaser is one who feeds a crocodile - hoping it will eat him last.
- Winston Churchill
If it walks out of the refrigerator, just let it go…
[Westech] 19:40: you try smacking it with a hammer?[Westech] 19:44: I tell ya it works!
Last edited by bubba_got_you; 12-24-2009 at 21:29.
__________________
SON OF A B/TCH TOOL: Any handy tool that you grab and throw across the garage while yelling 'Son of a bltch' at the top of your lungs. It is also, most often, the next tool that you will need.
An appeaser is one who feeds a crocodile - hoping it will eat him last.
- Winston Churchill
If it walks out of the refrigerator, just let it go…
[Westech] 19:40: you try smacking it with a hammer?[Westech] 19:44: I tell ya it works!
How is all your U joints on the short shaft and the other two?
__________________
"The right thing at the wrong time is no longer the right thing" Grandma Mattson
MVPA#22218
1954 Canadian M37 W/W "Oliveoil"
1971 M816 "Yard Whore"
1952 Curtis Wright M44/M34 "Mo gas momma"
1952 M42 project "money pit"
1968 M109A2 "camper special"
1986 M1028,1984 M1028,1983 M1028,1985 M1009
The list go's on but that would be bragging.
"I don't think the United States needs super-patriots. We need patriotism honestly practiced by all of us"
Dwight Eisenhower
How is all your U joints on the short shaft and the other two?
they are all getting replaced. the short shaft ones are fine the others are snapping so they are bad
__________________
SON OF A B/TCH TOOL: Any handy tool that you grab and throw across the garage while yelling 'Son of a bltch' at the top of your lungs. It is also, most often, the next tool that you will need.
An appeaser is one who feeds a crocodile - hoping it will eat him last.
- Winston Churchill
If it walks out of the refrigerator, just let it go…
[Westech] 19:40: you try smacking it with a hammer?[Westech] 19:44: I tell ya it works!
I need to rebuild my m37 t-case
