I got up this morning and asked myself ,What can I do that will make my Deuce look cooler!
Granted most of us are on budgets I decided to try a Deep water snorkil.I started out by getting all my rough measurements and off to the ACE hardware.
I bought: 2 , 4"rubber connectors
1 90 degree sewer street fitting(has a smooth end a female end)
2 feet of 4"pvc tubing
1 22 degree sewer fitting
2 4" hose clamps
you will also need a piece of either steel or aluminum 1" flat stock 1/4 " thick
My total cost in Florida was 41.65
Remove intake cap
Install 1 rubber flex fitting
install 90 degree 4 ' pipe with bend to rear
cut your 1st piece of 4"pipe(dry fit into 90
inatall 22 degree fitting (again dry fit)
install aprox 10 " x 4" pipe (go as high as you want)
install rubber flex fitting
In stall rain cap
When your happy with it being vertical and straight mark all your fitting
(I find it easy to do two marks on each fitting) prime and glue let set for 5-10 mins.
I used the flat stock and made a 1 inch x 2 inch x 1inch spacer and clamped it between the exhaust pipe and new air in take attach with 2 remaining 4 " hose clamps
I will take some close ups tomorrow All told 2 hrs with trip to ACE9They can cut Pvc to desired lenths their HOPE THIS HELPS