• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

 

Latest activity

BMI

SECO

Midwest Military Equipment

Eastern Surplus & Equipment Co

Staff online

  • R
    Ray70 replied to the thread Mep 803A.
    Not the first time I've seen that. Years ago there were a whole slew of rolling 803's at auction up at Ft. Bragg and all of them had the...
  • Mullaney
    Mullaney reacted to Adrok's post in the thread Fuel water separator question with Like Like.
    Petroleum ( fuel and oil ) floats. Opening the knurled connected drains the water. Just drain until definitive fuel runs out. If it is...
  • Mullaney
    Mullaney reacted to NDT's post in the thread Fuel water separator question with Like Like.
    Should be finger tight when you re-tighten it. The part is plastic so go easy on it if you use tools to loosen it
  • Adrok
    Adrok replied to the thread Fuel water separator question.
    Petroleum ( fuel and oil ) floats. Opening the knurled connected drains the water. Just drain until definitive fuel runs out. If it is...
  • R
    Ray70 reacted to Guyfang's post in the thread Buying MEP-803A - Good Deal? with Like Like.
    I look at this way different than most of everyone else here in the forum. I grew up supporting ADA, Air Defense Artillery. An...
  • Adrok
    Adrok reacted to Jonas947's post in the thread Fuel water separator question with Like Like.
    Its to drain the Fuel filter From water. Just screw off the whole filter. The bottom cap is not that cheap.
  • D
    DLippert posted the thread Humvee M1152 ac problem in HMMWV.
    When my heater is on and I switch to ac I hear a click under the dash the gage surges and the blower shuts off. When I switch back to...
  • Mogman
    Mogman reacted to Jinx's post in the thread Horn issues with Like Like.
    Just curious, did you try turning on the brake lights using the 3 position light switch? I know my truck does not enable the horn if the...
  • J
    j_boucher reacted to NDT's post in the thread Fuel water separator question with Like Like.
    Should be finger tight when you re-tighten it. The part is plastic so go easy on it if you use tools to loosen it
  • BLK HMMWV
    BLK HMMWV replied to the thread Horn issues.
    Exactly that's what I was thinking too. But it would be nice to find out what his problem is
  • NDT
    NDT replied to the thread Fuel water separator question.
    Should be finger tight when you re-tighten it. The part is plastic so go easy on it if you use tools to loosen it
  • Defcon-1
    It probably is if the main fuel-filter is doing its job / is being serviced routinely and drained frequently. I wonder what the...
  • C
    CSandoz replied to the thread Headlight, Running Light Help.
    The wiring harness only covers the headlights. The factory setup powers the headlights through the light switch. The aftermarket...
  • Jinx
    Jinx replied to the thread Horn issues.
    Just curious, did you try turning on the brake lights using the 3 position light switch? I know my truck does not enable the horn if the...
  • TOBASH
    TOBASH replied to the thread Anvil Motorworks Introduction.
    Nice work HummerHolic. I can vouch for this member’s product… the Hummer H1/HMMWV control arm bushing tool. Top notch in form and...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks