-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Latest activity
What's new
BMI
SECO
Midwest Military Equipment
Eastern Surplus & Equipment Co
Staff online
-
MogmanModerator
-
I was in an awkward spot with the buffer, and stood it too much on its edge and burned the clear real good. Getting to the center of the...
-
If you want a real loud blower type sound just replace the stock fan and clutch with a direct bolt on flex fan and put it on backwards... -
It was not bad, it did not do anything scary, I have been allot faster on scooters back in the day, the only thing crazy or maybe stupid...
-
HoveringHMMWV reacted to taskunitbruiser's post in the thread options for unarmored body holes with
Like.
I tried carriage bolts initially but didn't like the look and they don't lend themselves to tightening up well in this application since... -
I was in an awkward spot with the buffer, and stood it too much on its edge and burned the clear real good. Getting to the center of the...
-
The beauty of the clear coat system!
-
Seems like you either need to use lighter grit and sand a little less OR paint thicker coats. Been there. Done that.
-
Had a little whoopsie while buffing the hood. Burned the clear a little, right smack dab in the middle of the hood. Not a huge deal...
-
I was in an awkward spot with the buffer, and stood it too much on its edge and burned the clear real good. Getting to the center of the... -
Awol replied to the thread AWOLs 1997 M1097A2 Build.I was in an awkward spot with the buffer, and stood it too much on its edge and burned the clear real good. Getting to the center of the... -
The beauty of the clear coat system!
-
hooligan327 replied to the thread MEP803a Rough Idle.There wasn't a load on the generator at the beginning of the video. At that point the batteries were full and the inverter stopped... -
High Water replied to the thread 75w90 Gear oil.Thanks both for your input. Here is some additional reading if anyone like to geek out on this stuff... -
GL-5 doesn't supersede GL-4, they just have different properties. What CoachGeo is referring to is the EP (extreme pressure) additive...
-
using a GL-5 that is GL-4 compatible is fine. GL-4 (and compatibles) wont have detergents in them that cause issues with yellow metals...