• Government Liqudation

  • Latest Threads Activity


    continental multifuel injector ?

    Thread Starter: DaveP

    anyone able to tell me what the fuel injector spec's are? new engine seem's to run kinda rough thought maybe i should check injectors to rule them out

    Last Post By: Floridianson Today, 14:52 Go to last post

    Dual Circuit Brake Engineering Thread

    Thread Starter: frodobaggins

    --- If you came here by mistake and are looking for disc brakes...
    :You may also like to check out the "Disc Brake Engineering Thread"

    Last Post By: Jakelc15 Today, 14:45 Go to last post

    M1078 GVWR Over the Road

    Thread Starter: 504


    I did try searching this, I'm sure this has been asked before but I wasn't able to find the threads, my apologies.

    Last Post By: 504 Today, 14:03 Go to last post

    Down to the frame she goes!

    Thread Starter: ehuppert

    Been threatening to strip the 1008 down and rebuild from the ground up, turned out Saturday was the day! Got my three sons to pitch in, started ninesih

    Last Post By: nyoffroad Today, 13:56 Go to last post

    Rear square drive studs

    Thread Starter: coder123

    I'm sure this has been covered but I'm talking to guy a who says I must use the square drive studs on the rear of my M54 when I put super singles on....That's

    Last Post By: coder123 Today, 13:39 Go to last post

    Need a valve cover gasket........

    Thread Starter: Brad

    Looked over the net and can only find full gasket sets. Anyone know of a source for just a valve cover gasket for a GMC 6 cyll, M135?

    Last Post By: Brad Today, 13:20 Go to last post