• Government Liqudation

  • Latest Threads Activity


    Air Dryer(old style) Clean and Inspect.

    Thread Starter: Ronmar

    Took my Air Dryer apart, cleaned the components, washed the media and checked the heater operation. I did not strip the purge valve as it is operating

    Last Post By: Ronmar Today, 21:36 Go to last post

    Killing while idling.

    Thread Starter: theanimal

    It looks like my truck is dropping about 400 rpm when I put it in gear at idle and kills. I idled it up to around 900 and it drops all the way to 500

    Last Post By: Jbulach Today, 21:28 Go to last post

    What is the difference between the frames of the M998/M10XX/H1 Alpha

    Thread Starter: Hendrickson360


    recently i have seen a show here in Germany where they cut an old M998 in half to shorten the wheelbase and there it was said, that

    Last Post By: 86humv Today, 21:06 Go to last post

    what cordless tool are you using to get your lug nuts off

    Thread Starter: Jericho

    Just a quick survey. What cordless impacts do you find are powerfull enough to remove lug nuts, brand ,size, battery voltage ?

    Last Post By: davidb56 Today, 21:04 Go to last post
    dezert ratt

    What have you done to your 5 ton this week?

    Thread Starter: dezert ratt

    Hopefully theres not a 5 ton thread like this already. I tried search, and did not find anything. I just changed my 1st flat on one of the rear inner

    Last Post By: simp5782 Today, 20:57 Go to last post

    Luverne Style Brush Guard material dimension question for a custom build!

    Thread Starter: Keesyman

    Afternoon Gentlemen,
    I am looking to build a luverne style brush guard for my M998A1. I have access to all the metal and a full machine shop

    Last Post By: 86humv Today, 20:56 Go to last post
  • CptRaymond

    There is no available content written by CptRaymond