Search results

I think I found what I am searching for. SKF 18581 radial shaft seal with metal case Shaft diameter 1.875 in Housing bore diameter 2.623 in Seal width 0.313 in Just ordered, will see if it fits well.

My transfer is leaking and I have to replace the seal. I am looking for item 19 in figure 101. TM -34P // NSN 5330-00-079-1919 // P/N 11601229 // Seal, Plain Encased; Yoke Rear Is there any known source where I can buy one or any equivalent from the civilian market?

Hello Everybody, From the manual TM -34P I can see two different u-joints for the Deuce used on the prop-shaft forward rear axel to rear rear axle and trans to front axle. I do not mean the bolted prop-shafts. The lubrication fitting is either straight or in an angle. In my Deuce i've the one...

We have a company here in Germany. There they glued new pads without asbestos to all brake shoes of my Goat. Isn't a company like this available at your place? Have a look on their site to get an idea: Bremsen Schoebel

I purchased my M35A2 in 2013 and after disassembling, sandblasting, painting it is still a puzzle. But I hope to have the Deuce back on the road in 2024. With a title and license plate for a historical vehicle. Do not give up! I also have a M561 in my yard, partly restored. The carrier is...

A replacement to the newer 465 is an option we are thinking about. But this is the last option. A NOS 465 on our side of the pond will be up to $6,000.

Hi, Does anyone know of an inexpensive source or has a repair kit for the M35 LDS 427-2 engine? Complete kit with sleeve, piston, rings. Six needed. There was a complete set of six on ebay sold for $350. Memphis Equipment is asking $311 ea. which is $1,866 in total. P/N 5702644, NSN...

I need some help cleaning my data plates for the Garwood winch. I would like to make them readable again. Remove the old paint without destroying the original paint. In the past I was able to remove paint from my plastic vehicle models with brake fluid. Would that work here too? What are you...

When I am not wrong, Bavarian beer has less alcohol than Bavarian vine :cool: Perhaps I should bring some Northern German beer 💪 Okay, this is a forum about the green virus and not about the taste of the world. CU.

Guy, finally it went well with the spark plug I ordered. No idea what caused the problem on my friends side. But it is in now. Again, thank you very much for your help. Next time being in Franken, we should have a cup of coffee again (or a glass of wine or a nice Bavarian beer).

Thank you for the picture and for Garrett's video on YT. That is what I am looking for. Extremly helpful, very appreciated.

I'm currently working on the vehicle cab and have a question about the routing of the handbrake cable. There is part 14 in the TM and I no longer know where to mount it. The hole pattern fits in the cab so that I could screw the plate on from below. But then I kink the handbrake cable...

Hi Guy, It looked perfect, was ordered, arrived last week. And it does not fit :( The length of the spark is too short and the thread does not fit. Back to the beginning ... Who is Sherlock, who is Watson? Regards, Richard

Guy, that thing on ebay looks like 100% perfect. Thank you very much and enjoy today's coffee break with your family after doing this investigation. Thank you very, very much.

Guy, the spark plug is marked as Auburn S1-140-SG

Guy, I'll check. It is dark outside :cool:

Guy, The spark plug is there and the heater is working, but it looks like the spark plug will quit service soon. There is a number on it, but I am not sure. Something like S1-140-S0 81-140-80 61-140-60

Hello Guy, Good to know it is Winter time and you have the time to enter this thread. The heater is stand alone. So I assume it lost the relation to any trailer or whatever it was ever mounted. The -14 & -24P I just found on ebay. But it will take weeks to have them here in my hands. And will...

Hi folks, It is cold outside and I have here a multifuel space heater with a spark plug defect. The heater was made by Hunter, NSN 4520-00-114-1055. The spark plug must be replaced. My first thought was, to search for the part number. I tried to find the manual for the heater online by using...

Many thanks for all your hints. Found the problem and the solution today. The bolt for grounding the battery cable on the passenger side was junk. Drilled a new hole, took a new bolt and washers. And finally the Goat started like yesterday. While there was a metric bolt used by a previous owner...