Search results

  1. acthomp781

    M1009 transfer case leak

    Hello all. I have a 1986 M1009. The transfer case is leaking. I have done a search many times and have not found the same issue. It appears as though it is leaking through the yoke/u-joint, which would seem weird. I replaced the output shaft seal. The case is dry and the seal is dry. Tranny...
  2. acthomp781

    blown fuse

    Hello all. 1986 M1009. I searched quite a bit and found nothing specific to my problem. I installed an autometer water temp gauge. I tapped into the tan/white wire for ignition feed, right under the fuse panel. I ran a ground wire all the way to the location where I installed the sending unit...
  3. acthomp781

    rust repair

    Hello. I want to start with a big THANK YOU to everyone on this site. This site has made owning an M1009 much easier. I have looked, maybe not enough, but have not found any info on the rust I have. I want to repair this so it will not get worse. I am assuming the antenna hole on the passenger...
  4. acthomp781

    47,000 miles?

    Hello. The odometer states 47,*** miles, I am inclined to think it is 147,***. Based on these pics, what do you all think? Thank you for the replies. The rust behind the pass seat is, I think, from the antenna hole being left open.
  5. acthomp781

    New to this site.

    Hello all. I just picked up my very own M1009 last Saturday. It is a 1986. The PO converted it to 12 volt, with a momentary switch for glow plugs, I was disappointed with that, I plan to convert it back to 24 volt. It would start very hard, or not start. I looked up the TM for diagnosing the...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks