Search results

  1. G

    50/50 crude oil mix

    Just ran a tank of 50/50 crude-diesel through the old girl.Other than quieting down the motor dramatically, it appeared to run just as well as straight diesel. I may refine my filter setup,but the gauge on my small transfer pump didn't show any blockage in the filter. After I filtered it I just...
  2. G

    Driveshaft splines

    The 6-inch lift has the factory driveshaft all the way at the end of the splines (stretched to the maximum length). So with the shackles being at the rear of the leaf spring, I assume that I should measure to split the spline travel to be in the middle?with the shackle being in the rear is going...
  3. G

    Injection pump woes I think

    I recently acquired an m1031. Unfortunately I inherited the truck from my father, and it had sat unstarted for several years. It started right up with two fresh batteries.I noticed right away that when letting off the throttle that the truck felt as if it was going to stall. It also felt like it...
  4. G

    New m1031 owner returning after several years

    . As it says,new to me truck.Genset works perfectly.Returning member after several years.Switched hobbies for a few years and always seem to come back to a good heavy duty truck.
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks