Search results

Good idea having an electrician friend come over to supervise . will shoot it with the bowling ball cannon when we’re done.

Will do thanks

I understand that. wish I had a way to load it without moving it. crossing my fingers flying in the fog.

Thanks for that. Nice to have the help out there

It’s cold out, but I managed to pull the pump and give it a physical and reinstall pumping out of a diesel can. seems like it made it past 20 minuets but it still failed and began drooping after warm up. it’s always gotten better each time I tried something and timed it. Put it back together...

Got it. will do that tomorrow. thanks

I’m on it thanks

No load

Thanks went ahead and replaced with one known to be good with the darn same results. still scratching.

Went ahead and pulled a pump and filter known to be be good and installed on the unit. ran fairly steady for 19 min and began to droop. drooping continued for another 10 min. Until it was swinging like a pendulum between 56 and 64 HZ seems like it takes it longer each time to fail. It started...

Got it. sounds like we’re testing the primary. I have another identical unit sitting next to it that runs flawlessly. does it make sense to swap the primaries out or switch with the auxiliary ? am looking for a replacement for the small filter. took it off awhile back and it looked fine and had...

had another go at it. unplugged the A2 fault indicator or the malfunction indicator as described on the schematic. thought we had a chance for awhile. Took 15 minuet’s to begin drooping. Temp never exceeded 180 degrees. oil never went below 42 psi. When the drooping became excessive I shut her...

Have not adjusted the frequency. it continues to run well for 10 to 15 minuets. Have changed the filters and drained the fuel tank and scoped it. no dirty filters or debris. Have a clear stack and oil and temp readings look good. it consistently begins to droop after it reaches operating temp...

Will take a look

Update on the Mep 803 a. hours on the machine are 209 total. Changed filters and checked fuel cap. it was rusted and turned off. repaired rotten return line. Engine will now run normal for six minuets. had electrician check output. Appears normal. never put it under a load. As soon as the...

Thanks for that. will get back to you with results.

Thanks will try that. will take a video if it doesn’t work. will reply back after I acquire a long Allen wrench.

No load have a couple of these and they run smooth with or without load. would like to take it to a Gen guy with the knowlage and tools.

Have a low hour 10 k MEP-803A generator. located south of Dallas. In need of someone who can work on mine. it runs and puts out, but won’t run at a steady Rpm. thanks