Search results

  1. Artisan

    BIG CAM 1 OUT, BIG CAM 3 GOING IN

    He picked up my 5ton for me years ago at Ft lewis. First thing he said was THEY GO FAST! ha! I am not sure if you see my name or not but tell Brad you have been conversing w/ Brad the plumber in SO Calif... Mike this is the throttle posistion switch I believe yes? It looks like I need to...
  2. Artisan

    BIG CAM 1 OUT, BIG CAM 3 GOING IN

    Mike, BE SURE to tell Brad Milne you and I have conversed... I am SURE he will tell you about our run from Los Angeles to the PNW, he in my 5ton loaded w/ 10000 pounds in the bed AND pulling a 8 wheel trailer w/ a 20' shipping container on it and me in the 20 ton hauilng the same. OMG! Brad...
  3. Artisan

    BIG CAM 1 OUT, BIG CAM 3 GOING IN

    Thanx Mike... I think it is already on the new engine... I will photo it and verify. Mike can you name all these sensors? The new engine has just one (the center one ) on the drivers side... https://www.steelsoldiers.com/threads/artisans-m916.122713/page-30#post-2269280
  4. Artisan

    BIG CAM 1 OUT, BIG CAM 3 GOING IN

    Mike excuse me I did not see this. ( I speak w/ Brad Milne about once a month just because...) So the BC1 engine were pulling out had jakes. The new BC3 has jakes too. Shouldn't I just be able to connect the 3 wires at the top of the engine and it will work ok? EDIT: We have a resolve for the...
  5. Artisan

    BIG CAM 1 OUT, BIG CAM 3 GOING IN

    Wes and Mike consider follwing my thread! (Mike do you know Brad Milne in WA? ) I need all the help I can get! ha! The TM says I need 3 Assistants, PLUS me! HA! I had one guy for 45 minutes so far pulling the rear two motor mount bolts and assisting on the lift to remove the old engine...
  6. Artisan

    BIG CAM 1 OUT, BIG CAM 3 GOING IN

    Thanx Mike, I assume it is a normal right hand thread...
  7. Artisan

    BIG CAM 1 OUT, BIG CAM 3 GOING IN

    I see said the blind man as he picked up his hammer and saw. THANK YOU! THANK YOU! THANK YOU!
  8. Artisan

    BIG CAM 1 OUT, BIG CAM 3 GOING IN

    Mike, I found a dial indicator that doesn't break the bank... I wish spinning the crank was that simple and do I have to go one particular way only ? As you see there is no center nut...
  9. Artisan

    BIG CAM 1 OUT, BIG CAM 3 GOING IN

    So if you care to lend advise (or watch me make mistakes) my Notes / SS Blog is here; ARTISAN's M916 https://www.steelsoldiers.com/threads/artisans-m916.122713/page-30#post-2269989 I have a NIB Military BC3 that I am putting in my M916 and pulling the bad BC1. As I understand it, I have to...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks