Search results

  1. PointnShoot4WD

    New country, new Goat

    Shite and briney, back into it. Overnight rain hasn’t amounted to much thankfully. Start with the center left, drum tight, jacked it with the screws and still not able to pull off. Didn’t want to take the wheel off just yet so moved to the front left, figure the pads would need a clean up...
  2. PointnShoot4WD

    New country, new Goat

    Vacuum bleeder was incredibly convenient, near empty rear reservoir in the master cylinder was concerning. Topped the master and then left it for the afternoon have another go on the ‘morrow.
  3. PointnShoot4WD

    New country, new Goat

    Got back to working on my lawn ornament over the weekend, replaced wheel bearings on center left and cleaned up the pad and drums. Bearing swap out was surprisingly easy for inner race, purées well stuck behind the spacer/brackets. Little bit of Brinelling but not bad. Noticed thread goop on the...
  4. PointnShoot4WD

    Gasket P/N needed

    Can give you an engine number to use...
  5. PointnShoot4WD

    Personnel heater and Napa U-joint P/N

    Images as promised. Regards Spock
  6. PointnShoot4WD

    Personnel heater and Napa U-joint P/N

    I can get some pics of the heater fuel feed from mine over the weekend, not that it seems to be working right now, need to replace the final line to the heater anyhow.
  7. PointnShoot4WD

    New country, new Goat

    Tweaked the governor and got a bit more, haven't checked the throttle throw yet, where was the adjustment point? Under the tunnel?
  8. PointnShoot4WD

    New country, new Goat

    Yep, the cold drums were lubricated internally and the hot ones had dry bearings. The centre and rears are running about the right temperature now, fronts are still cold (adjustment coming up) and needs another bleed, the pedal drops to the floor on the first push. Thanksgiving weekend will be...
  9. PointnShoot4WD

    WSUCougarx's M561 Gama Goat Acquisition and Build Thread

    A timely post/find, just bought a set of doors in similar visual condition and will likely have to replace the window as well, tempted to install flymesh and then have the clear roll up an zip/velcro down. Spock
  10. PointnShoot4WD

    New country, new Goat

    This is what brakes look like when dot 4 is mixed in to dot 5... deja vu, new slave cylinders, flush and hope the pads clean up...
  11. PointnShoot4WD

    New country, new Goat

    Big thanks to Elijah95 for the float across from LA, arrived safe and sound in Senoia from whence it was picked up on an equipment trailer and hauled to Augusta. Had half a chance to get sorted and over to Durhamtown, but it was not to be.
  12. PointnShoot4WD

    rear goat covers

    https://www.beaudeserttimes.com.au/story/5967705/scenic-rim-veterans-go-for-a-tamborine-tank-ride/ Tim got the bug, then had to find a way to make it supportable. He has a **** of a vehicle collection, all kept as running examples and is supported by/employs local veterans to help maintain...
  13. PointnShoot4WD

    rear goat covers

    My bad. Yeah, no access to a rear cover, yet. Should have one coming with my new acquisition. Spock
  14. PointnShoot4WD

    I need missing manuals in PDF format

    Agree, strip the seats out, ‘centre’ the transfer levers, all knobs off and remove four hold down bolts. Then jiggle and balance and hold your tongue a little more to the left. Getting the tunnel back on was worse. Spock
  15. PointnShoot4WD

    I need missing manuals in PDF format

    I think I have PDF of some of them, but that nomenclature suggests these are the mid to late 80s reprints. For what you’re talking about, the original issue manuals should cover as well. Spock
  16. PointnShoot4WD

    M561 from California to Georgia

    For a single float move, sure, but no reason it won't fit on a car carrier if ones headed in the right direction. If it's the going rate, then I pay it, just looking to see what options might exist. Spock
  17. PointnShoot4WD

    Fuel gauge sender

    Magical -20P says your numbers for the gauge are 6620-933-3600 and MS24544-2. Common M-series and listed under M151 parts as available at TNJ. Spock
  18. PointnShoot4WD

    Fuel gauge sender

    M38 from what I was reading mate, but it's worth a try with the 715 unit if you've got it out.
  19. PointnShoot4WD

    M561 from California to Georgia

    Anyone got recommendations for getting a GAMA Goat from Rancho Cucamomga to Augusta? Plan to self drive fell through and 4K seems a bit steep. Spock
  20. PointnShoot4WD

    M561 transport - California to Georgia

    Anyone got leads on a reasonable car carrier to transport a GAMA Goat from Rancho Cucamonga to Augusta? Spock
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks