• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

 

Search results

  1. CycleJay

    M1009, Marietta area, Voltmeter needle going to red on right side of meter.

    Hi guys, I just recently replaced the passenger side alternator (and the 2-wire plastic connector.) and rear battery because they went bad. Now the truck starts and runs, however the voltmeter needle on the instrument cluster stays in the green to the far right, until I put the gas pedal...
  2. CycleJay

    M1009 Gen 2 Battery.

    Hi guys, I just have one quick and simple question. Which battery is connected to Gen 2. The front or back? That is all... I do not remember.. Thank you... CJ
  3. CycleJay

    M1009 4wd question.

    Hi guys, I have a simple question, about the M1009 while in 4WD mode. Is there any limit to the amount of miles you can drive, while in age stage of 4WD (high or low and front hubs locked.)? I ask because I live and work in the Atlanta area, so I was stuck in heavy traffic for 10+ hours...
  4. CycleJay

    GA to PA - Between 5 days from today to Christmas

    Hi Guys, Anyone making a trip from Georgia to Pennsylvania, or even close to a route like that. I need transport for 4 people plus about 1 rooms worth of belongings, and perhaps a small 4 door sedan with a blown engine. PM me if any of you will be making such a trip and have the ability...
  5. CycleJay

    Atlanta, Ga area to Portland, Maine or Connecticut area.

    Hi guys. Are any of you in the Atlanta area with an MV Cargo truck, Going to be making a road trip to either the Portland, Maine area, Or Connecticut, within the next few months? If so, please let me know. I might need help moving myself, my M1009, And a few belongings up that way. I would...
  6. CycleJay

    Denver, Colorado to Atlanta, Ga., complete M1009 needing moved. (Not confirmed yet)

    Hi guys, I have NOT bought this vehicle yet. BUT I would like to know IF I did. How much do you think it would cost to move a complete non-running M1009 from Denver, Co. to Atlanta, Ga. ? Or are any of you making that kind of trip any time soon? Thank you. Good day. By the way, I need to know...
  7. CycleJay

    M1009 Headlight problem.

    Hi guys. My M1009 is having a problem. Yesterday all my lights were working fine, (headlights, taillights, etc.) This morning all my lights were working fine except for both headlights. I bought 2 brand new headlight bulbs, removed the old headlights, installed new headlights. Now, I still...
  8. CycleJay

    Trip to Washington DC

    Hi guys, My M1009 "RumbleLina" and I may be (not confirmed yet) taking a road trip to Washington DC, June 26th, 2013. So I can be in Washington June 27th, 2013 for a possible meeting at 11am. Any advice, hints, contact info., anyone have, so I can make sure I get there and back in good...
  9. CycleJay

    M1009 Fusebox/wiring harness..

    Hi guys, Anyone have one or know where I can get an M1009 fusebox/wiring harness? I would like to get at least the fusebox. That is the part I would like to replace. It should be an actuall M-Series CUCV or M1009 fusebox, because if I remember correctly, there is a fuseslot for the blackout...
  10. CycleJay

    M1009 Parking lamp/turn signal socket.

    Hi guys, Anyone know where I can get a parking lamp/turn signal socket for the passenger side, front end of a M1009? Mine needs to be replaced, the contacts in the socket broke off.. Atlanta area preferred so I can get it right away, and fix it right away. Any ideas would be greatly...
  11. CycleJay

    M1009 Fuel sending unit ground wire

    Hi guys, Just some simple questions... What gauge is the black ground wire from the fuel sending unit to the frame? Or what gauge should it be? And what size is the ring terminal at the end of that wire that connects it to the frame? Thank you...
  12. CycleJay

    M1009 directional control/turn signal switch

    Hi guys, On the way home from work, today my turn signal switch broke. When I took the part number and searched the oreilly's site. It gave me two results.. an ac delco, and a bwd switch. They both look a little different from each other. So which one should I use? Or does anyone have...
  13. CycleJay

    SeaFoam motor treatment in vacuum lines. M1009

    Hi guys, Since putting SeaFoam in my fuel tank after my last fill-up, I have noticed a change for the better. So I would also like to run it thru my vacuum lines to clean that system too. But the instructions on the can do not explain how other than to say use a little at a time. So How...
  14. CycleJay

    Seafoam question

    Hi guys, I have a fairly simple question. I would not think doing this would cause any damage or problems. But I wanted to ask anyway. About a month ago when I last changed my oil, I added a quart or two of the Lucas oil additive, and since then I have had better acceleration, etc...
  15. CycleJay

    US military may be getting a new toy too...

    Hi guys, I like the look of this one. Looks like it would be fun to play with at a Georgia rally.. http://www.foxnews.com/leisure/2012/10/22/northrop-grumman-unveils-proposal-for-next-us-special-ops-vehicle/ Just my $0.02 cents
  16. CycleJay

    The Australian military has a new toy...

    Hi guys, Check this out, looks kinda cool.. http://www.foxnews.com/leisure/2013/01/09/australian-military-testing-new-special-forces-fighting-machine/?cmpid=prn_o_o Just my $0.02 cents
  17. CycleJay

    M1009 Fusebox questions.

    Hi guys, My M1009 is beginning to have fusebox problems. I have checked the TM's for a part number for the fusebox under the dash. But have not been able to find it, found diagrams of the box, but no part numbers. Anyone know the part number? Anyone know where I can get a new one? or a...
  18. CycleJay

    Goodyear Wrangler Duratrac tires.

    Hi guys, Do any of you have any opinions on those tires, and their suitably for an M1009? Any information would be appreciated. Thank you...
  19. CycleJay

    Pro comp es9000 shocks, question? And opinions

    Hi Guys, I tried searching for an answer to these inquiries, but could not locate anything helpful. 1st question: If a pair of those shocks are bought brand new, then stored in their boxes in a home for 4 years, and never used. Would they still be good to install now? or would they have...
  20. CycleJay

    For the love of God! Please go fix the issues and go back to the previous format.

    No offense... But since this new format, whatever you want to call it was implemented. There is one thing at least that is next to impossible to do. That is send/reply to and/or receive PM's aka Private messages. I have tried to answer 1 PM now several times, and ever single time, the...
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks