Search results

I was thinking about installing a small tank for diesel when I am starting and shutting down my truck(M1008). Anyone set a system up like this?

Anybody ever see one of these? I was thinking about hooking it up to the M1008 for winter up here in Michigan. GM Part Number 22511639

What is the proper tire rotation on the M1008? Back to front, cris-cross, etc...?

I am going to start running wmo in my m1008. Has anyone installed a fuel line heater, if so which one and could you please post pics of the setup.

Anyone know the width of a bed cap for the M1008?

Attached is the bottom of my power steering pump. There is a bolt coming out of the pump but does not appear to be long enough to attach to the bracket? Is this suppose to mount under here? If you have a picture of the proper mounting, greatly appreciated.

I am going to paint my 1008 next year CGI 383 next year. Some will be new panels, some will not. What type of primer is suggested?

I drive about 60 miles to work on the interstate. Would it be better to swap transmissions or change the gearing for highway travel?

Cold up here, but it will not start. Cranks over fine, new glow plugs last summer. Fully charge battery. The glow plug lights come on fine. I sprayed WD-40 and Starting Fluid(yes I know it is a bad thing to do) just to try to get it to kick over, but nothing. It just keep cranking until I...

I have had 4 GlowPlug wires catch on fire this summer. I do not know if it is short in the glowplug or an issue with the wire and possibly as mouse. What should I use to replace the glowplugs and wires? I am not sure if I want to patch the wire or install a new run. Is it part of the wiring...

I went to start my M1008 and noticed smoke coming out from under the hood. I investigated to see the wire on the last glow plug closest to the firewall on the drivers side on fire. I promptly put it out with water. The one wire is gone, no smoking now and the 1008 starts. Any ideas? Wire...

As the title describes, my transfer case is leaking on my M1008. I live in Jackson, MI. Any suggestions on a shop/person to take it to for repair? Many Thanks

I am thinking about hooking up an electric snow plow this winter. How was the wiring handled to supply power to the pump. Thanks

I have an m1008 CUCV and I believe the batteries are shot. I have looked around in the forums about a replacement. Although replacing with originals would be nice, it is both time and cost prohibitive. I see from many post that I should try to aim for 1000 CA and around 800-900 CCA. Does...