Search results

Does anyone have the dimensions on the clutch pilot bushing? I know it's has a 3/4" bore. I can't see paying $18 for one they are available much cheaper from commercial suppliers I just need to know the OD and length. Thanks. Eddie Cannon

I am looking for some advice. I have my injection pump removed for service and wanted to replace the rubber boots on the injection lines. I have a set ordered but looking at the lines I am not sure you can install them over the end fitting. Does anyone have any advice on that? I don't want to...

I will be replacing my injectors on my M35A2 truck in the near future. I have several sets available I can use. I have the older style shim adjustable 2 hole units AKF 130S 6614A and the later AKN 130SM 6844 B2 ones. The AKF ones are brand new Bosch units and they pop test at 2750 PSI. The AKN...

Ok I was in the process of replacing all the hoses and belts on my M35A2. All was going well and I was able to replace the water manifold hoses and the oil cooler ones without much issue. I went to replace the lower hose and man what a pain. I had removed the generator belts and rotated it out...

I am think of fabricating a remote reservoir for M35A2 brake system and probably mounting it in the cab. I also would have it so I could pressurize it and use for a power bleeder. I am looking for input and any issues with this idea. I own a fab shop so building one is no issue just not sure how...

I picked these up today. I got a snatch block and a 50' Kevlar pendant. The pendant is a helicopter lift sling rated at 74,000 lbs break strength.

Hi I am new to the MV hobby. I recently bought a M35a2. I do commercial sand blasting and welding as a side line. I have been blasting for the last 20 yrs and have much experience doing body panels and parts. I have a large system that I built. the compressor is a 375 CFM unit hooked to a 6000...