Search results

Truck starts no problem, voltage climbs into the red. After about 40 seconds it drops immediately to the green. Couldn't find anything in the TM. PMS Mag refers you to higher level maint. Guessing its the voltage regulator??

Thanks.

Anyone have the auto part cross referenced p/n's for '93 6.2 M988 radiator hoses and belts. The NOS belts off ebay are off alittle, one belt gets loose as you tighten the other. Bought the return over fill tank return off ebay and it is short. thanks

Found 4seats on GL, not sure what they originally were for, took a chance and they worked out better than I could have imagined. The seat flips up to access the storage below and they give whip lash protection for the kids. I made the spacers out of 1" aluminum stock. While the seats are...

I have the chance to pick up a 2011 new in the box tri cooler (Oil/Trans/PS) pretty cheap. I've read that they have 40% more volume for increased cooling capacity. Has anyone done this or heard of anyone installing one a 6.2 A1. My oil cooler is pretty beat up. Thanks. Dave

Searched and read accordingly. Wait light and glow plugs previously worked fine, then nothing. Rotating switch to glow plug position "wait light" illuminates for a split second. No power to glow plugs (mulimetered) Disconnected batteries prior to all wok accomplished. Installed brand new...

Air pressure builds quickly to 65 psi quickly in both tanks and stops at 65 psi. Air starts leaking from the bottom of Air Governor on the passenger side of the governor and won't build above 65psi, if I bump up the RPM you can hear an increase in the volume of air leaking as the compressor...

Looking for the length of the bumper on an M35A3 end to end. Thanks, Dave

I just got the FL title for my duece, I am planning on selling it. When I do, can I just transfer the FL title, the next few blocks say dealer reaasignment, or do I need to retitle in my state. Thanks

Watched the bidding go to 3000 - 3400.00 per set of 4 2 weeks ago. http://www.govliquidation.com/auction/view?auctionId=5110678 Today I won 2 sets of 4 wheels and tires for 1000.00 ea.:mrgreen: Sometimes it pays to wait.:beer: 2530 - Vehicular Brake, Steering, Axle, Wheel & Tract...

Anyone know off hand the height, in inches, from the floor of the trailer bed to the tarp and bows, my trailer is at a different location, otherwise I would measure myself. I need to pick up an A/C unit that is approx 43" high. Thanks , DJD

I finally got around to installing a new Western Pro 7.5 Ultra mount on the old girl. I was even able to keep the brush guard on . 3-400 lbs of ballast in the back seems to be about right for traction. It will be nice to plow a few of the smaller lots with the CUCV instead of the crew cab F-250...

I recently had the honor of winning 2 MEP-003A's with 2.3 & 2.1 hrs on them. I know what you are thinking, just a repainted piece with a new hobbs, that's what I thought, so I didn't bid on the first 10 that went up on GL back in Nov. I went to pick up another genset I had won and asked the...

Anyone have any luck finding the oil filter numbers or fuel filter numbers? Just picked up a genset and looking to change the fluids, got lucky new battery and is in real nice shape. 29 hrs on hobbs, rivets are shinny, no overspray on any lines or fittings, looks like it was just pulled out of...

I picked up another mep-003, no filters at all, I am good with all the p/n's for the filters and I know the strainer is not available. My question is, what micron water seperator/strainer should I get. 10, 20, 30 micron? I was looking at this one. West Marine: 200R Spin-On Series Diesel Fuel...

Looking for Hertz and percent load gauges for MEP-003. Generator fires right up, volt meter works fine, I can see condensation and rust of the other 2 guages. Thanks. Dave

I got to preview this one a couple of weeks ago and won it last week. The engine looked like it was taken out with hardly any milage on it. The whole engine has that new engine look, paper stickers intact and legible, no tool marks on any bolts, clean inside the hoses. Even the headers look like...

I am okay with the house part, have a secondary electric panel with a manual switch to isolate from power grid. My question is what kind of power cable should I be looking at. The genny will be approx 100 ft from the house. I saw this on ebay, any thoughts? 2/0 GENERATOR CABLE, UL LISTED, W/...

So I noticed the battery setup on my newly acquired MEP-003 is not the same as my M1009 CUCV. I figured that since it was going to be 24 volts it would have the same in series type setup as the CUCV. I would like to add a solargizer to the batteries, do I need a 12 volt for each battery? or am...

Flew over 2 dueces on a lowboy on I-95 north bound in MD yesterday, circled once for a closer look, red tractor with either Rob's or Bob's on the side. 15 miles or so North of Balt, past Martin State. Anybody here?