- 912
- 1,287
- 93
- Location
- Wilson County, Texas
Sounds like a cool project. Did you get it going?
-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
MEP-831A Oil Pressure Sender Suggestions
- Thread starter kloppk
- Start date
- 1,962
- 3,054
- 113
- Location
- Pepperell, Massachusetts
Yes
I had bare printed circuit boards built a while back, built up a few units sent unit out for beta test.
Once beta testing was completed I had to re-spin the bare PCB design and received the new versions yesterday. Started populating the first one with components last night.
Waiting on delivery of a re-supply of some components which are common to my other MEP products and that had been used up producing them. They are due to arrive at the end of the week.
I anticipate testing the final version of the combination Governor Controller/WiFi Remote Start system sometime next week.
I had bare printed circuit boards built a while back, built up a few units sent unit out for beta test.
Once beta testing was completed I had to re-spin the bare PCB design and received the new versions yesterday. Started populating the first one with components last night.
Waiting on delivery of a re-supply of some components which are common to my other MEP products and that had been used up producing them. They are due to arrive at the end of the week.
I anticipate testing the final version of the combination Governor Controller/WiFi Remote Start system sometime next week.
- 912
- 1,287
- 93
- Location
- Wilson County, Texas
So, I will hold out on getting one of your controllers untill this WiFi one is ready. ��