Results 1 to 2 of 2

Thread: RG31 A2 windshield repair

  1. #1
    Corporal Anvilface's Avatar
    Join Date
    Mar 2019
    Location
    Wilmington Nc
    Posts
    40
    Thanks
    0
    Thanked 11 Times in 8 Posts

    Default RG31 A2 windshield repair

    Hey guys, I've been working on an RG31 A2 (M1236). Running good and looking good, except the seal has failed on the windshield panes. I found a youtube video on how to separate the lexan covering from the first layer of laminate and remove it. He stated that was the common area for those to fail. Looking at them, it appears that is where they have started to separate.

    Is there any other wisdom I need to know before I pull the armor off from around them and start separating them from the truck?

  2. The Following User Says Thank You to Anvilface For This Useful Post:

    USAFSS-ColdWarrior (04-16-2019)

  3. #2
    Corporal Anvilface's Avatar
    Join Date
    Mar 2019
    Location
    Wilmington Nc
    Posts
    40
    Thanks
    0
    Thanked 11 Times in 8 Posts

    Default

    Just a follow up. Took them out (not that big of a deal, they are in frames).

    The failed layer was on the inside 1st layer. It took a little time but it peeled right off and cleaned up nicely.

    The only down side is that each window weighed over 100 lbs, not easy to manipulate without dropping them.

  4. The Following User Says Thank You to Anvilface For This Useful Post:

    USAFSS-ColdWarrior (05-08-2019)

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •