Results 1 to 5 of 5

Thread: Wiring a M38A! 12V system

  1. #1
    Sergeant Major
    Join Date
    Oct 2013
    Location
    Central, MS.
    Posts
    173
    Thanks
    20
    Thanked 23 Times in 17 Posts

    Default Wiring a M38A! 12V system

    I just wrote a long explanation to the problem I'm having w/ wiring in a new SRS (starter relay solenoid).

    It included where my wires are connected and etc. I posted it and was asked to log in again...consequently the entire message vanished when I did this.

    I need help in wiring a 4 post SRS to ignition switch and 12V coil, where the "I" post goes to and "S" on relay and some other itemss Thanks
    Last edited by gringeltaube; 09-24-2019 at 07:21. Reason: fixed typo in title

  2. #2
    Sergeant Major
    Join Date
    Oct 2013
    Location
    Central, MS.
    Posts
    173
    Thanks
    20
    Thanked 23 Times in 17 Posts

    Default cont. on wiring for M38A! 12 V SRS

    I'll continue, post and continue till I write the post I orginally wrote.

    I have the pos. batt. cable to left side SRS large threaded bolt along with a wire from it to the BATT on the ignition switch.

    The "S" post on the SRS goes to the "S" post on the IGN. switch.

  3. #3
    Sergeant Major
    Join Date
    Oct 2013
    Location
    Central, MS.
    Posts
    173
    Thanks
    20
    Thanked 23 Times in 17 Posts

    Default contd. SRS on M38A!

    I'm not clear on the "I" post on the SRS. I read it goes to the + side of the coil but woulodn't that interfere with the operation og the "S"

    post on the SRS since it energizes the "I" to allow continuity between the two largr side posts on the SRS to activate the starter?

    The right side large post has the cable going to the starter.

  4. #4
    Sergeant Major
    Join Date
    Oct 2013
    Location
    Central, MS.
    Posts
    173
    Thanks
    20
    Thanked 23 Times in 17 Posts

    Default cont. M38A1 wiring SRS

    Bought a new 4 post SRS and finally discovered it was faulty by trouble shooting it.

    Took another SRS off of another Jeep and it did turn over the starter but jeep was in gear. Eventually it stopped working and now making a chime or buzz noise.

    Battery is low from all of this so I had jumper cables hooked to the low battery on the jeep.

    Are the wires connected corrected w/ exception to where to connect the "I" post ?

    Any suggestions? Thanks

  5. #5
    Sergeant Major
    Join Date
    Oct 2013
    Location
    Central, MS.
    Posts
    173
    Thanks
    20
    Thanked 23 Times in 17 Posts

    Default

    Problem resolved

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •