M543 Clutch petal goes down but stays there

Went to start the 543 yesterday and when I let go of the clutch pedal it stayed on the floor. yes the clutch was actually disengaged. I shut it down and checked back about 10 minutes later and the pedal was back up and the clutch engaged. Checked it again today, same story. Is this a linkage or a pressure plate issue? Thanks, Gregg

If it’s a wrecker, check the clutch engagement lever back at the crane controls.

Thanks I will do that...Gregg

Mike,
Thanks. The clutch engagement lever was in fact up. Disaster avoided. Gregg

Knew it! good to hear it was the issue.

Never too old to learn something new