Results 1 to 2 of 2

Thread: HMMWV Tan Soft Slant Back Kit $575, Delivered CONUS

  1. #1
    3 Star General
    Join Date
    May 2016
    Location
    Alexandria VA
    Posts
    876
    Thanks
    25
    Thanked 641 Times in 368 Posts

    Default HMMWV Tan Soft Slant Back Kit $575, Delivered CONUS

    Clearing out stock, last item until another production run.

    This kit allows you to cover the rear bed of a 4-man HMMWV with a reasonable equivalent of the fiberglass or aluminum slant back. The frame was made by me from electrical conduit tubing and a mix of factory and homemade fittings. Frame is covered in pipe insulation foam for padding of the cover. The center panel unzips along the sides and can be rolled up and tied to leave the back open.
    These covers are my own design, roughly on about Mk 3 of the iterations, for those following along.
    This one is made from 1000D Cordura Nylon, past models have been weathering well. It will fade unless treated. Marine vinyl protectant works well.
    Some pictures can be found here: https://www.steelsoldiers.com/showth...=1#post2184435
    My thread about the development of these is here: https://www.steelsoldiers.com/showth...Top-Slant-Back

    A typical build involves roughly 3.5 yards of fabric, 40' of velcro, 60' of stitching(!), 50' of tubing, and many hours of cutting, welding, sewing and fitting.

    Shown is the actual item you will receive.

    Bulldogger
    IMG_2066.jpg

  2. #2
    3 Star General
    Join Date
    May 2016
    Location
    Alexandria VA
    Posts
    876
    Thanks
    25
    Thanked 641 Times in 368 Posts

    Default

    Bump

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •