Are these 105 racks on backwards??

Noticed when I tried to put the front rack on that it was too short. Looks like they need turned around.....

You usually know for sure when you try to lock in the front to those two sides.

Yes, pull them up and out then turn them around and put them back in whit the wood slats facing in.

Also, if you have the panel for the rear of the trailer the rectangular brackets on the side skirts of the trailer are where you put that panel when not in use. It'll stay there without being tied down. I put mine on the driver's side so I can see it but it can go on either side.

Lance

I always run my wood slats inside, and the extra unused bow holders at the front of the trailer.

wood needs to be on the inside

Thanks to all. They will be turned around shortly!

No problem, and good luck! Hope they don't fit as tight as VSE rebuilds do...