• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. F

    24 volt alternator vs generator

    Has anyone swapped their generator for an alternator? I am in the process of doing a motor swap and figured it would be easier to go to a 24 volt alternator. Any suggestions. Thanks in advance.
  2. F

    M 715 motor swap

    I finally got the motor to go without cutting the input shaft, now to weld in motor mounts and do the wiring.
  3. F

    M 715 motor swap

    Called Novak and they are supposed to get back with me
  4. F

    M 715 motor swap

    The motor came out of a 79 Chevy with granny low four speed and the input shaft where the pilot bushing rides is 1 inch on the Chevy trans. and 1 1/2 inch on the T98 so I think your right Larry, I think I have to cut the input shaft a 1/2 in. shorter.
  5. F

    M 715 motor swap

    Used the alignment tool and pulled motor back out and rechecked, everything is lined up and the firewall is not stopping me yet
  6. F

    M 715 motor swap

    Small block to T-98 Need help Putting the SBC 350 to T-98 and it will not go the last 1/2 inch. I have the Novak adapter the right pilot bushing and I cut 1 in. off the throw out bearing carrier on the T-98. Am I overlooking something? Any help would be greatly appreciated
  7. F

    M 715 motor swap

    Novak told me that the only mounts they carry any more is the weld in type. I am not going to cut the old ram horn mounts out to weld in the Novak mounts. I will have to figure something else out, any help would be appreciated. Thanks
  8. F

    M 715 motor swap

    I registered on the M715 Zone but cannot post anything for some reason
  9. F

    M 715 motor swap

    Going to call Novak today
  10. F

    M 715 motor swap

    I need a little help. I am attempting to install a small block Chevy in place of the 230, I will be changing nothing but the motor, I purchased the trans. adapter and it looks like it will work fine but the motor mount kit from Novak has a small piece of channel in the kit that the instructions...
  11. F

    M-715 Throw out bearing retainer

    I read somewhere that if doing a small block Chevy swap and keeping everything else original you have to cut 1" off of the original throw out bearing retainer. Is this correct?
  12. F

    Hello from Henderson Tn. M715 owner

    Building my M-715
  13. F

    M715 Throw out bearing retainer

    I am putting in a small block Chevy to the T-98 and was wanting to know if I have to cut the original throw out bearing retainer?
  14. F

    M 715 motor swap

    M 715 bell housing Was wondering why I have to use the spacer ring in the bell housing with the Novak adapters, because the way the adapter mounts nothing fits in the bore of the bell housing to make a difference
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks