Search results

here is a pic of the bearing . the rest of the clutch was in great shape saved me money.

could anyone tell me if this is an evens fan clutch i need to rebuild it and saw a kit on eastern surplus and want to make sure im getting the right one?

WOW that picture is exactly what i needed.. THANK YOU

m939 its an old hard copy i have i don't have an m923a2 one.

does anyone have a diagram for the fuel tank. for the life of me i can find it in the tm. i need to know what the pick-up tube goes in to at the bottom of the tank.

OK i worked my way back from the secondary. as long as i kept filling it up through input elbow it would run next i blew out the feed line from the tank. nothing i then removed the solid feed line going into the tank . recleaned and blew it out.. FIXED .....there must have bee a...

should i not be filling the secondary filter before using the priming pump

I've change both fuel filters on m m923a2 before with no issue. this time i removed the tank and cleaned all the gunk out before changer the filters. i topped off both filters and pumped till fuel came out of the bleed screw. truck started and ran fine for a few minutes then died. i...

i just found a fourth o ring inside the small whole. I'm leaving for now because it looks ok.

one o ring was split and another had disintegrated,

THANKS

My fan actuator is leaking air from the smaller hole on the end cap. i cleaned and lubed it but still leaks air. i was wondering if it should have an o ring. it did not have one when i took the cap off?

i havee an actuator that is leaking air through the tiny hole - not the larger hole in the end cap...i cleaned and lubed it. still leaks. should there be an o ring in there. when i took in apart it did not have one?

THANK you so much!

forgive my ignorance - what engine oil weight do i use for my 923a2?

sign me up and merry christmas

my m923a2 had air escaping from the air dyer took it apart and decided not to rebuild just replace. replaced and all was fine for a few mile and it started leaking out of the same blow out valve. i am at a loss any ideas out there? i used a punch to press the valve closed a virew time...

I am also have an air dryer problem the air dryer was leaking air out the blow out hole. tried to free up the valve with a screw driver still wouldnt seat. took the dryer off and was was pretty far past a rebuild so in put a new dryer unit. worked for the first few miles then the...

does anyone have an NSN or aftermarket part # for this?

thanks!