Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
thanks for the reply.
I tried with and without bulb in the turn lever with same results.
they seem to be wired correctly as the turn signals come on front/rear and the bo work as well just don't blink?
I'll take the flasher unit off and clean up the ground.
I used my air grinder with 80 grit...
Sorry I just saw these replies. I put all my incandescent back in my truck except in dash/cab and everything worked. I waited till I got my replacement stock led brake and turn signals and then tried again. After installing new led turn signals and brake lights same results. They just light up...
I didn't even think they unscrewed, I'll have to check that out tonight. Is everything there to attach wire on the other end or do I need to purchase the other half of the connector.
Thanks I was looking for more of what type of connectors they are not how to connect the system. I know how to wire it but I don't want to have to cut off the ends because I don't have a way to connect to yellow connections. I would like to have a charging feature.
I have everything but the solar panel for the pulse tech charging system. Does anyone know the pinouts for the solar panel input and the wattage/voltage of the panel. I going to try and find one on ebay. Also, what type of connectors are the yellow connectors?
I've gone through all 5 TM's and I can't find anything on servicing the winch on my M925A2. I just want to make sure fluids are good in it but I can't find anything on it. I had a couple questions in particular.
What is this on the top left of the winch and I have also seen these on the...
Like I said I replaced ALL the bulbs including the one behind the switch to led and I even have it out right now. The only light I haven't replaced are the backlights for gauges. I'll take a look at the module tonight and see what version it is. Thanks
Anyone have the part number for the updated flasher unit or a way to tell which is which. I'll keep testing I've changed just about every bulb out to led that I can easily access.
I replaced all my light bulbs inside and outside with 10-30v led bulbs and my front signals are acting up. When I read the voltages on the lines I get 16 top, 24v middle and 6v on bottom lamps on the front turn signal. Also, when I turn on the signal it just lights up and doesn't blink. I...
Midway through this thread it turned into a pulsetech thread for a minute. Anyone know a replacement solar panel for the pulsetech system, voltage, wattage on something that I could wire into my push button controller. I have the circuit breaker and push button controller but would like to...
after I turn my truck off and have the spring brake set I can hear a small air leak on my back right air brake. It is leaking at location in picture. Could this be a seal or diaphragm? The brake is holding but wasn't sure if this was part of the spring brake or the air brake which was...