Recent content by kfrosty

Just got a PM on this, Spicer 5-153x u-joint kit is what I recall working on the front drive shaft. The spicer 2-70-18x Bearing strap kit is what I wrote down as working as well. I had zero luck at Napa for finding a crossover when I did this.

Yes I fixed it, I'm pretty sure I got it from Kascar but I can't remember off the top of my head.

Don't bank on that always. I thought PayPal was always fair and sided most of the time with the buyer. Until I purchased to 5 ton tops from GL. I got them took the wrap off one and found that one of the tops was dented by a fork lift. Whomever did it wrapped shipping wrap around it to hide...

I saw your PM. The short answer, anybody can try to do anything they want. Businesses now a days like GP and most use fear to try and force you into their BS. You can write anything you want but what do the federal laws and laws of your state say. Just call your credit card company and...

2-70-18x Spicer Bearing Strap kit looks to be the correct one for from ujoint. The 5-153x just arrived and fits the yoke out of the transmission.

No it just broke. The U joint broke and an ear off the shaft broke and then 2 of the bolts in the retaining strap broke. But I can't tell which was the cause because towing it out caused some of it. If I had to guess, the u joint broke and then ear on the shaft and retaining bolts on one side...

Napa part UJ430 is the u-joint I got. On their website, Bearing Cap O.D. 1 1.063" Bearing Cap O.D. 2 1.125" Construction 2 ISR (Inside Retained) & 2 OSR (Outside Retained) Inside Lock Up 1 2.375" Lube Fitting Location In Cross Outside Lock Up 2 3.218" Series Ford The...

They didn't have the spicer for the staps and their cross match in store brand wasn't 100% exact. The bolts that came with it was a size or two bigger and wouldn't work. They actually did have the Spicer 5-213x in stock and again the cap span was too great. The part number you posted was the...

Update - Went to Napa and 5-213x doesn't work, it's too wide to fit into the yoke that goes into the front of the transfer case. We tried their napa crossover as well as a spicer 5-213. Tip to tip is too long but about 1/4" to 1/2". The guy there measured and found UJ430. However two of...

Thanks!!

http://www.steelsoldiers.com/showthread.php?78861-TM-s-for-the-M998-series TM9-2320-280-24P You can start on page 136-2.

I had a drive shaft break and replacing parts. The cap on the front shaft that comes out of the front diff and is in the Center support bearing lost a cap, so I'm looking to replace it. Searing on ebay comes up with a 5-174x spicer. However, on my u-joint, one side has B7, the other side 151...

Has anybody tried getting the transfer case out without dropping the fuel tank? I've got a hole in the transfer case in the truck, I've been debating whether to try and epoxy the hole or pull it out and swap it with another I just got. It looks like it would probably be tight but 50/50 as to...

For what it's worth, I have one that is intermittent but always starts easily. After you've started if it's warm the light want stay on. Also, in addition to the clunk, watch the voltage gauge. On all of mine when the plugs kick in you see the drain on the batteries. When it's done, the...

Based on numbers from Action, I found this 12338334 That looks like the line that comes from the Transfer case and threads into the transmission. Of course 12447075 looks somewhat similar as well.