Recent content by mikelee

I agree with the above......Check extinguisher just in case.....never know:popcorn:

Article in manual has a step to setup. For proper shifts just need to make a gauge block for setting gap. And use a vaccum source for setting (I used a vaccum generator) Like the one Harbor Freight sells well worth the time to do this.

m1008 just not a daily driver.

Been There Before:evil:

Jb weld and most epoxies will not take direct heat . Some can handle 500 degrees.

Post in the Elvis section

:ditto:

This could start more Elvis sightings...:shock:

I run goodyear wranglers

:ditto:

I agree seems some of these prices I have seen seem inflated.

all work with the key off :ditto:

saturnsurplus.com has gauges shows in stock N.O.S

check ground wires clean terminations and use corrosion prevention grease . never hurts to do this anyway. Somewhere some one put a slogan on here if it is electrical clean it and if it is rubber replace it .

Welcome, Sorry to here about the loss of your son. You will find a lot of info here and great group of folks willing to help. Looks to be a nice truck. Send in some more pics when you get it.