Recent content by ParamediCUCV

Just installed some Ranchero shocks, transmission cooler, and fog lights; replaced the front brake pads, and cleaned the rear drums to get rid of that awful squeaking. Now my M1009 rides like a dream!

I just had my transmission rebuilt; the torque converter for a gas engine is a 3 lug, while the diesel one is a 6 lug. Apparently, the previous owner had rebuilt my trans with a gas converter, which put more wear and tear on it due to the increased torque of the diesel engine. It sounds like...

Just dropped my M1009 off at the garage to have the tranny rebuilt after burning out a clutch plate; front seal was leaking slowly, then decided to give while doing 65 mph down the highway.

pics???

That is true, DH, and the engine was warm since I had been driving it. I don't have the GL relay, but the push button mod., so no glow plug boom, but thanks for the input. I didn't think to mention it to the others about that important detail. As far as the fuel gauge, I'm in the middle of a...

That is true, DH, and the engine was warm since I had been driving it. I don't have the GL relay, but the push button mod., so no glow plug boom, but thanks for the input. I didn't think to mention it to the others about that important detail. As far as the fuel gauge, I'm in the middle of a...

That's a pretty cool looking dash you got there Brett!!

I looked into the vinyl overlay, but to get a good product, I'd end up spending as much on a commercial pad. Besides, I wanted something that I could customize easily. I'm not one to tear holes in the vinyl to attach something to the dash if I need to.

After I finish applying the foam, I'll use the same adhesive to stretch some scrap fleece over it to give the fiberglass resin something to adhere to. Then I'll add a sheet of fine-woven fiberglass on top of that, let it dry, sand and paint.

BTW, make sure you have a good quality duct tape, or else you'll end up using most of the roll to hold the foam to the dash; it beats trying to hold it for 10 mins. by yourself while the glue drys!

I started on my dash in what little spare time I have. Here are some pics to start with. I used sleeping pad foam with HI-Temp spray on adhesive.

I used some belt dressing, and applied some LOCK-TITE to the threads of the bolt to make sure it vibrate out. Worked so far...

Thanks for the reminder. Just sticking my head under the hood while a stranger started it was nerve-wrecking enough for me. I don't plan on blowing myself up...but then again, who does?:lol:

While headed to a friend's house, I ended up running out of fuel in the middle of nowhere, in the pitch black of night, and without a working flashlight. Had some diesel in the back, filled the tank, and bled the filter per the TM, but it just wouldn't start. Ended up calling AAA for a tow...

Replaced the old door locks with new ones; lubed the window cranks, reattached the rear view mirror (again!), and sanded down the dash to steel for refab.