-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
rickf's latest activity
-
Rick, FYI the one LITD linked to above is the same one I had mentioned in my P.M. I've used a few of them in the past, you just need to... -
rickf replied to the thread MEP003A frequency meter in-op.Thanks guys, for that price I guess it is worth a try. I am going to open up the control box first and make sure all the wires are...
-
rickf replied to the thread CARNAC's Historical VIN INFO Thread.You created a monster Carnac! :ROFLMAO:
-
rickf replied to the thread MEP003A frequency meter in-op.I will look it up tomorrow, I know I should look up in the manual where the transducer is but can you clue me in and save me some searching?
-
rickf replied to the thread MEP003A frequency meter in-op.Are the transducers available at a reasonable price? If not I will simply go aftermarket and bypass the transducer.
-
I just picked up a 003 with 8 hours on the clock. This thing appears to have been mothballed after testing since the convenience outlets...
-
rickf replied to the thread MEP-802A questions.If you go to the top of the generator forum , on the right top you will see a button that says "post thread". This is where you start a...
-
rickf replied to the thread MEP-802A questions.That was a subtle hint from Guyfang about starting a new thread for this so I will wait for that thread to say anymore.
-
Dont forget, M116A3. The A3 is important. And when you start your own thread, we can give you lots more assistance.
-
rickf replied to the thread MEP-802A questions.The trailer nomenclature will be on the tag on the trailer tongue. It would be a 116, 105 or 101 most likely and I believe the only one...
-
rickf replied to the thread MEP-802A questions.You really should start a new thread. But a single 802 would have come on a 416 trailer would it not? They did not have a jack leg, just...
-
Well the day has come, The new button was installed. I redid the flow test and #16 button was right on the mark. after putting...
-
Good work getting it going again! In the video I could briefly see the volt gage, which looked to be way above 240V ( assuming you have...
-
As Guyfang has told many folks and with lots of direction on this site. The TM's are your friend. Parts manuals and instructions make...
-
rickf replied to the thread Need a top bow for a M116A2.Thanks for the heads up, I get a message there that I do not have sufficient privileges' to reply. "You have insufficient privileges...
