Recent content by WhitePhoenix

My entry, what an amazing opportunity!

IN

IN

In for a cargo cover and a bow kit! How big of a box is the bow kit in? Only asking since all I got is truck space in a car.

Just a heads up for everyone, I just spent a few days working out of El centro/Western shore of Salton Sea and the winds were reaching upwards of 40 knots, blowing a lot of sand. It would be a good idea to bring some kind of eye protection from all the blowing dust and something cover your...

Even though the Navy has brought me to the west coast, my 923 still resides in the Three Rivers area with the folks.

Recently moved to San Diego from Pensacola, FL couple of months ago. M35A2 waiting to get moved here.

So I can shed some light on this as I just became a Naval Aviator that flew the T-6B less than a year ago (NAS Milton, not Corpus but regardless and the older looking planes are T-34C being completely phased out by the T-6B). There are landing/taxi lights underneath the inboard side of the...

Looks like work is going to keep me a bit longer then expected, should be rolling in around 6-7 Friday night. Is there a number I can have to contact in case I get randomly lost trying to trek my way there?

Just moved to the San Diego area recently, looks like a good time so count me in. No MV as I have yet to move my deuce here yet, so just the civy truck for me. Depending on work, it will be later afternoon/night Friday before I would arrive.

Yup that was the 1st thing I had checked in accordance with the Troubleshooting TM. Going to pull the starter and have it checked out by a local shop here cause that's the last link in the chain.

It did help sort of, just matched up the wires to their respective numbers and how the connector from the start plugged into the other receiver. And I finally understood how to bypass the switch, which I tried to no avail and pulling the starter tomorrow to get it checked out. Now the only new...

Just a quick question, on the back of the switch, which slots do wire 127 and 174 go to? The wiring diagram shows 74 and 74A going to B & D, and that's throwing me for a loop right now.

118, 119, 127, 174 are the wire numbers.

I have read through that thread, how do i specifically test that the twist switch is bad (as in where to put the connectors from the multimeter and what voltage/amps/resistance should I see)? The whole bypassing the switch is still a bit confusing aswell, if someone can point me as to which...