Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
I just found a 20"x9" wheel. It is one piece, tubeless and steel. I have seen some on the M105's that were 22.5. Any thoughts on what they were for? I wish I could find a set.
I just won an auction for 5 new 1100r20 tires for my bobbed deuce. Can I reuse the 900x20 bias flaps with the new tires (same stock wheels)? I think I am going to get the wheels refinished at the same time $22 each. The tubes are also $22.
A while back monster man & Joe Young made a heater instalation manual with a bunch of photos. It's still listed on the resources page but none of the photos come up. Can anyone help? I am also looking to make air intake scoop. Do anyone have the mesurements? Westfolk just sent me a link for NOS...
I have a 24v-12v coverter. It is rated for 10 amps. Could that be hooked up to a 12v battery like a charger giving me a 12v system that would allow me to run larger loads than 10amps for short periods of time? Would it over charge the battery or taper down like a battery charger?
Does anyone know anything about an M38 with 1100-20 tires and a cut down body. Fred Chrimson has a couple of photos in his book. It may have only been tested. They refered to it as "Hi Helen".
I just came across German Army issue antenna for the SEM-25 radios. The discription said they work from 25mhz - 70mhz. They have a tuning box with them but there is also a remote unit that tunes the antenna which isn't incluided. I would like to use this with a CB set, 27mhz. The antenna needs...
I just won an M101 trailer that I need to pick up next week. Does anyone know the ID of the lunette ring. I may use a ball hitch adapter to tow it home. I couldn't find a manual for it only the newer m101a series trailer, is it there?
I just won an M101. I've checked for a manual on the site and only found the newer m101a manual. Am I missing it? Does anyone have the electronic version that they can post or send to me? I may want to sell my WW2 Converto trailer, needs restoration, now.
I lost my drain plug (bottom) from my axle. Not while driving, while doing a lube change. I am sure I will find it as soon as I buy one. Anyone know what size it is I think it is 3/4" pipe thread. Gasket? Material? I know I could pull the other one but I am leaving on a trip in a couple of days...
I am a little out of place here. I just got a CJ7, haven't even picked it up yet. Does any one know if there are any free manuals on line. If I had found a military one I would know right where to look. I know she has some frame problems. If anyone has parts or even a frame let me know.
I just bought some new toys. One of the things was a trailer dolly. It is a tandem axle commerical rig, 8 tires, Dayton rims. I can't decide if I should keep it to go with the Deuce or sell it. I have a good set of NDTs I could put on it. I need to pick it up soon and will take some pictures then.
I have the rear axle apart to change over to singles. I ordered new seals and brake cylinder kits to be replaced at the same time. Nothing is leaking, I just thought it would be easier just to break it down once. The cylinder bores look good and shiney. Should I just clean it up and replace the...
The compressor wrenches are finished and the first one went out today. See the classifieds. Would anyone be interested in a Fuel Injector Pump wrench? This is the spanner that is used on the IP hub.
I need to replace the two universals on the drive shaft between the transfer and the front-rear axle (Middle). I have looked at the parts TM's and can't figure out which ones I need. Some of the drawings show a carrier bearing, mine doesn't have that. Also my universals have clips not flange...