Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
I have a m100 Dunbar Kapell delivered in April 1951 but cannot tell what the vin/sn is. Does anyone have the range of the numbers based on an April 1951 delivery date.
WE are running!!!! Hop on! Used #6 TDC technique because timing marks are hard to see. Then adjusted distributor till points opened. Pulled started....bateries were weak. I allowed the engine to get to operating temperature before shutting it off. Then started it up using starter. It worked...
Double check the points gap. I decided to see if #6 was in sync with the timing marks. I unscrewed the access plug over the piston, then place a 16 gague wire down into the hole. Rotated the motor until the wire reached the maximum height of the stroke. Looked at the rotor button to see if it...
Only thing I was able to do was apply direct power to the distributor via the starter. I wanted to bypass the ignition switch to ensure there was not a problem in it. NO LUCK still dead in the water.
Replace all plugs and the old ones were good as well
I will use my jeep to check the plug wires tonight. I replaced all my new jeep plugs with those I took off the the m37 and all are fine
Here is an update I am getting 24 volts on the primary terminals and the secondary when the points are closed I do not get any ...well maybe just a little current through the secondary. I will check for spart at the plug tonight. I am going to set up a camera and record the plugs firing. Also...
1. Comp 90psi all pistons
2. Plug wire ohm to 0 no resistance and no leakage to the jacket 3. Plugs appear serviceable set at 30 guess that is ok I cleaned them.
4. Internal dist cap had no cracks. The spring to rotor button ohmed out to 0. But when ohming from the spring side of the cap to...
I am having a similar problem. Situation: 1. New Fuel Tank, Electronic Fuel Pump, fresh Gas; 2. Cranks with ease but before I can drive without it being sluggish I have to let it warm up to operating temp. If not some times it boggs down and even back fires. Some times it even bogs down after...
I need to purchace the center hing for my M37B1. I have the left and right hinge and am assuming when I purchase the tailgate it will come with the rods attached that will mate with the hinges. However I cannot find a picture of the center hinge or any for sale. I am considering going to a...