Search results

Was doing a little prevent maintenance in preparation for next months turkey hunt / M923A2 road trip & camping adventure. While I was crawling around the front differential I noticed this bolt wedged near the leaf springs on top of the axle.. directly under air compressor / fuel control area...

No cucv just my trusty M923A2..

Good info, thanks for the post.

home made shift level decal Mine was warn off. I couldn't locate one so I just made a quick pdf file. (L) decal pdf, (C) home made decal, (R) old original sample decal 1. I printed off the pdf and cut out the decal 2. applied a strip of clear heavy duty packing tape to both sides of the...

Thanks all. Now just waiting on a flood of them to hit the auction.. Not ready to pay $10k for a non running 1078 just yet.

Cool congrats on your new rig!

Some may of not liked GL but I have concerns about Iron Planet as well I have my concerns regarding IP. One big concern is not being to do a onsite inspection of a vehicle before I bid.. For example several M923's are listed on IP but they only list the state in which they are located, and not...

Looking for info on jumping a M1078 vehicle with low/dead batteries (I don't have a m1078, just trying to become a little more knowledgeable of them). Does the M1078 have the newer style 1-pin Slave Cable Port/Connector that is found on vehicles such as the M923 / M939 series? Can a M923 be...

??? If you are talking about a M939A2 series truck wouldn't you want the drain closed and then open your bleeder (pictured) while pumping.

Thanks for the heads up on the alternate locking fuel cap source, just saved me $40

Napa P/N 655-1320 http://www.steelsoldiers.com/showthread.php?127737-M923A2-cab-heater-blower-motor

Just used the Napa p/n motor as a replacement for my inop heater fan on my M923A2. OEM is a single wire replacement is 2 wire (extra wire is a ground).

Got it. Thanks again to all..

CARNAC, "Hmmm, didn't read post #1 on the vin info thread." I did read the post if this is what you are referring to. "NLOVHK" is all alpha characters, no numbers.. my vehicle is ser number 23/followed by numbers.. This MFR doesn't address or list 6 alpha characters only, unless I missed...

Thanks for the info.

? Registration number.. At unit level? It's not on my gl paperwork..Utah title, registration or the truck ID plate..

Mine as well as a few other trucks I've seen have "NLOVHK" stenciled on the inside of the cab doors. Anyone know what the acronym means?

How did the tranny respond to long-term use of trans fluid versus engine oil?

Did you open the vent screw while you were hand pump priming? (TM 9-2320-272-23-2 dated 10 Sept 2012, , WP 0329, step 1, Fig 1, item 6 and 7) I will be doing mine very soon..

Trailboss, Here's a better look at them... Safety Note - Always chain them to your tailgate hinge so as they are securely attached...my torquey 700cc ATV tried to spit the ramps out the back as the front wheels came in contact with the cargo bed and only the rear wheels where on the ramp going...