Search results

How does the 5 ton horn button work? I can't see anywhere it's grounded. Is one side of the solenoid hot all the time? Odd circuitry.

Old gal didn't even strain dumping it and another big one in front of it

This is the most useful military vehicle I’ve ever owned. The other ones were just really cool grocery getters.

Will the Delco 33 SI alternator work on my five ton with the J180 mount? Delco 33 SI

Where is the best place to source a good quality keyed ignition for the five ton? I bought one from Those Army Guys or whoever they are for a previously owned truck, and it was junk.

Imagine that, an issue with the CTIS. I have attached a link to a video of my truck. The rear axle quick release valve does this, then stops, repeatedly and eventually all tires will deflate. No flashing codes. I looked at the TM, but it isn't very helpful. Also, the link to the Dana Diagnostic...

Need help getting a pallet from Aiken, SC to Perry Florida or close. Thanks!

What's the valve between the driver's door and seat near the rear of the cab for? I tried turning it, but it appears to be stuck. I haven't traced the lines out yet. Is it the valve that switches the fuel tanks perhaps? Also, does the dump bed latch close automatically when the bed is lowered...

I need a little help troubleshooting the hydraulic system on my newly acquired dump truck. I have many years of experience operating machinery that uses hydraulic pumps, but have never wrenched on them much. The pump is cavitating, very noisy, and the bed is very jumpy when raising it. The...

Had an excellent turnout for the festival this year. Many folks from the Florida MVPA attended. Thanks to FMVPA member Dan Simmons for all the hard work and organizing everything, as usual. Don't have many pictures to share, but if anyone who was there is reading this, please feel free to post...

I have a set of infrared lights and I'm not sure which connector is positive or negative. Does polarity matter on them?

Anyone on here done a restomod on a M37? Thinking about selling my MK23 and doing one.

My TIM module boots up, displays the "TIM module working correctly" message, but will not allow me to do anything. Test and other buttons are unresponsive. Any ideas?

MEP803A dual genset with transfer switch. This is mounted on the transfer switch housing.

I have two MEP803A's on a trailer with transfer switch. I do not have the generators grounded and was temporarily running a water pump. I switched to the #2 generator on the transfer switch to send power to the pump and when switching my thumb inadvertently made contact with the indicator bezel...

The fan on my truck engages automatically when first starting for about 15-20 seconds, then disengages. With the air system pressurized, engine off, key on, when engaging the clutch manually, the fan physically moves in towards the engine. However, when sending air manually with the engine...

I thought if you were a paying member, you weren't subjected to the ads? There's a new one now, that creeps up from the bottom of the page.

Anyone know if a 939 cargo bed will fit on the MTVR?

Seems my rear axles are very noisy, especially when decelerating. Is this normal? Also, what temperatures should the hubs run after driving a bit? Last, what engine oil pressure and coolant temp is normal once the vehicle is warmed up to operating temp? Thank you.

Mounted on the firewall. Maufacturer says it’s proprietary and can’t sell it to me?