Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.
I ordered 4 new 60 amp right away, if I need more, I will definitely reach out
I totally understand about not wanting to part with the 100amp cord
Mouser shows more 100amp plugs are arriving in April so hopefully not too long of a wait.
Besides a Siren I purchased from a fire house and my...
Ok thank you I will get a better pic of the smaller
looks like this is the 100amp based on your number
it says they have 14 arriving in April
https://www.mouser.com/ProductDetail/Amphenol-Aerospace/MS90557C44412S?qs=32nMTUtgvjSSnQMdacK5Wg%3D%3D
Hi everyone
I am looking to connect my MEP-805B to this panel
I need the female 100amp plug and we’ll as multiple male plugs
can anyone direct me please?
thank you so much
So I got most of the job done.
I still have to replace the return fuel line and tube as well as remove the original lines.
The filter bracket was too low so I had to flip it around and also had to drill new holes in the mounting plate on the truck to shift it over about an inch.
The one fuel...
Just to update
I went with new AT3's 100% tread from Feltz tire 715-305-3853
Dustin was great to deal with
$350 per tire
Shipping was $692 from WI to Long Island for 6 tires
I am having the same issue on my truck.
It took like 6 to 8 cycles of the starter before it lit up yesterday.
Today after one cycle and not starting, I cracked open the bleeder screw with a 10mm wrench and used the hand pump twice to prime it and got fuel to squirt, tightened the screw and tried...
Put the top on today
we mounted the back portion 1st which went well
the top didn’t fit perfectly in the front and I am missing the 4 brackets that lock down the top on the inside
Thanks for the replies
I will have 3 guys total.
The bed is empty so the plan would be to assemble in the bed so less to lift.
Did you use any sealant on the front lip or just the gaskets?
So I bit the bullet and have acquired a NOS hardtop for my M925a2
Any advice as far as install?
I believe gaskets and hardware are included
I would like it sealed as best as possible
thanks so much
That would be great.
I recovered my 1082 last year, used it 2 more times and it aired up fine.
I tried to use it again last week and I couldn't get the brakes to release.
I noticed the secondary tank on my 925a2 would not really get over 30-40 psi once I opened the valves to air up the trailer...