Search results

@KN6KXR I ran a 1/4” low psi hyd hose from the case drain port, to the return line elbow at tank. I havent noticed anymore fluid running out of the rope drum (seals are shot) or out of the rgb vent. There might still be a minute amount that enters, but i have not needed to crane but a couple...

took what fitting off? Where was the fitting located?

where did you put the fitting that drained back into the tank? If i had the mwo, i could reference it for fitting placement. Im heading to hyd shop now to get an npt to jic then a 90 fitting with a m swivel and fm nipple and get 8’ of -4 low psi hyd line and run it into the tank near the tank...

I cant seem to find the MWO or the thread about the MWo for the crane winch motor case drain MWO. I did use the search engine, probably not using correct key word search, and i looked in the TM section but nothing on the case drain. Any help will be greatly appreciated.