-
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Search results
-
3 finger Pressure plate difference??
Yep New everything including resurfaced flywheel., I took her out again ( sprayed a can of brake clean up there ) and it did not seem to slip as much but time will tell. TO bearing will spin by hand ( screwdriver ) with tranny in neutral and clutch pedal released so its definetely not making... -
3 finger Pressure plate difference??
OK Took her out for a run and the clutch slips like crazy in 4th and 5th, checked the throw out bearing and I can reach up with a screwdriver spin it so clearence is good as far as clutch pedal adjustment goes??? going to buy 2 cans of brake clean and spray it up in the housing and see if that... -
3 finger Pressure plate difference??
OK Tranny is in, I did have to reclock the arm on the shaft spline, it was not that hard to do ( less than 6 swear words ) being when everything was out I pulled the shaft and arm and cleaned up and oiled them and reassembled loosely so it wasn't that bad to remove and rotate it a few... -
3 finger Pressure plate difference??
What I think I need to reclarify is that I was hoping to reset ( preset ) the shaft rod while I had the tranyy out. What I think I might do is put the old 4 finger back on the ( resurfaced ) PP ( along with new clutch plate ) and measure from the pp to the end height of the fingers then put the... -
3 finger Pressure plate difference??
Good point about measuring from the plate to the fingers, I'll check that on both tomorrow. I guess I won't really know until its all bolted up., I should have measured finger height on the old one before I took it off the flywheel then compared it to the ( bolted up ) new one..Dang I hate... -
3 finger Pressure plate difference??
Its 3.25" ( aprox ) from the hole in the lever to the tranny flange., I got the new 3 finger pp today and measured the overall height/depth of the pressure plate, the 3 finger is about 3 1/2" to the end of the fingers ( yes I took out the wedges ) and the old 4 finger is about 3 3/8" so I'm... -
3 finger Pressure plate difference??
Guys I'm replacing my old 4 finger PP with a 3 finger one and my question is ( for any of you that have done this ) was there any difference in the throw, I thought I read somewhere that someone had to reset the shaft rod position on the spline ( see pic ) to make up the extra slack being there...