Recent content by RICE670

I am planning on camping and bringing the 151. Scott

I second this idea. I have 3 of these trucks on the back burner now for a few years.

Welcome from the green section of NY.

A needle scaler is a good alternative to blasting. The thicker and brittle the paint the better it works. Also keep the needles ground flat for better performance.

Dan , Check out the G838 website there is a post and a link for this topic . LOoks like the will fit.

Another veiw

I have only seen one on e bay. This one looked NOS and works perfectly. It has a built in 80 amp 24 v generator. Supposed to have 4- 6 volt batteries, but I have it loaded with 12 volters. The flame is gas oil mix from the generator fuel tank. The heat is directed with stainless 3 '' flex pipe...

Slave kit, all self contained 6 12 24 volt start/ 100000 BTU heater. 1 issued per 25 truck in artic conditions. Supposed to start vehicles down to -60 F.

The TM needed is 9-4940-468-13 Tool Outfit,Hydraulic system Test and Repair unit (HSTRU)

I have one also.Still has the original markings. I have the side rack hardware, missing the wheel and end gates.

trailer pics.

Hey Jeff, Yes I will be camping there. Looking forward to it.I am glad it was not needed.Fires SUCK!

Mine is 997B also. Just about a year old. Still looks goodMostly out off the weather ,but not always.

Some more pics. I picked it up today. It will bend and Flare up to 1 1/4 tube. Assemble no skive fittings. Pressure test hoses and tube up to 5000 PSI. Built in parts washer, transfer pump with bulk filtering . LOts of hand tools, super nice flow meter.There are 15 of the red tool boxes stowed...