Kevallarist
New member
- 6
- 2
- 3
- Location
- Clermont, Florida
Hey all! Picked up my M1101 the other week and have started breaking things down to prep for lining (inside will be black, outside ill be doing in a desert tan).
was curious if anyone knew of a good way to flatten the pictured indent on the top side of the outside wall. This is right where the drivers side wheel well is so there is no way to get to the underside of the dented piece worhout some cutting.
any ideas would be greatly appreciated!
was curious if anyone knew of a good way to flatten the pictured indent on the top side of the outside wall. This is right where the drivers side wheel well is so there is no way to get to the underside of the dented piece worhout some cutting.
any ideas would be greatly appreciated!
Last edited by a moderator: