Search results

I’m looking for a DAGR mount plate like this:

I have some green aluminum troop seats in crates with hardware. $250

I bought 5 new wheels/tires and one has been damaged, it would be a spare but not sure it’s even good for that. Does anyone sell just the half of the wheel I would need to repair?

Let my hmmwv sit for a few weeks and on startup immediately heard a new noise. This happens for the first minute or so, maybe only while the glow plugs are cycling? Once warmed up I drove it around for 10 minutes and didn't hear it again. Let it sit overnight and started up again and same...

I was assessing the damage under this patch to see why it was there and maybe repair it. What is on the backside here?

So this morning I planned on draining my geared hubs and inspecting the locking spindle nuts. Got to the first one and the plug was already a little rounded off inside so I knew I was in for a good time. I got the torch out and heated up the plug, gave it a few taps with the hammer then tried...

I'm in the process of restoring the DWF kit on my m1123. Most of it was left in place during demil, only the cdr valve and selector valve were removed, the lines were left in place but cut. My problem is what I'm reading in the DWF instructions doesn't seem to match up with the lines/hoses...

I'm in the process of putting everything back together after replacing my injection pump and I'm not sure how the rod from the pump to the fan cut-off switch is supposed to be connected. I can't find this piece in the TM, where is this supposed to go? Does anyone have a pic of how theirs is...

I'm trying to find part numbers to for a couple idler pulleys so I can remove my sanden compressor that was part of the red dot system I removed. I might just be looking in the wrong TM for parts numbers, below is what I've found. TM 9-2320-280-20-2 shows a diagram with a...

Is there supposed to be a drain hole here somewhere? Water collects in the valley, I've tried cleaning it off but its a hard to see area and I can't find any hole. This is a melton rebuild in an m1123:

Recently picked up an m1123 and have been going through and fixing all the issues I can find while waiting on my SF-97. This one has me a bit stumped and looking for some help. I noticed when I picked it up I couldn't push the accelerator very far, barely above idle. I disconnected the...

Looking for TM 9-2320-387-20 and have been unsuccessful finding it, does anyone have it?

Looking for transportation for an M1123 HMMWV in Leesburg, Georgia 31763 delivered to Liberty Hill, TX 78642.