Search results

Anyone know where to get them. When I sent my manifold back to CM automotive they lost some of the fittings.

Im going to send my CTIS to get reprogrammed and a solenoid replaced. Does anyone know a good way to plug it so I can still drive it?

The trans temp has always read on the high side of the guage, like in the 270's. I suspect the guage is wrong because pan only is 160 with a temp gun on the worst days. I also noted it was highest with synthetic AT fluid and has dropped with standard fluid. I also added some thick Lucas and it...

Just wondering who drives there deuce everyday. I have been driving mine since I rebuilt the motor in January. I have put over 2000 miles on it since then and have done lots of long road trips. Can I keep driving this thing every day or will it start to fall apart? How many miles have people put...

Does anyone know where to get the shocks. After I bobbed mine I never put shocks on the back and I want to do that now. Does anyone know where to get these?

Just wondering how everybody is wiring there trailer brakes. I have my controller in the vehicle working. Just wondering if people are jumping the brake signal off of the headlight switch. Then I was also reading the circuit number is is there a wire number 53 for electric brakes in the back...

Does anyone know where to get a relay that will switch 24v. I tried an standard bosch relay and tried to run the coil side of the relay and it smoked the wires like there wasnt even a relay in the circuit.

My CTIS doesnt power up. Dumb question but are there fuses on a A3 and where are they? Does anyone have a wiring diagrams for the CTIS. I found one in the TM but it doesnt have all the wires that go to the controller. Does anyone know of a more in depth diagram they can point me to. My CTIS wont...

Im sure this has been discussed but can I just run my 12v stuff off the battery that is closest to ground? I am running a duel battery setup? Or does it somehow run that battery down?

I have harrowed it to not be the ram but the rod that controls the ram. The reason I can say the ram is good is I have no leaks when I blow air into each side with compressed air. It almost will fully turn the wheels doing that but it wont. So I have the other usit off that runs from the pitman...

Have people used the stock driveshaft and kept the axle location with that or is it too short? I plan on shortening the existing bed. Also when you mount up the springs in the rear do you mount shackles reverse or forward?

Sorry for the short introduction but I just picked up a 93 M35 today. I got it for $3k with a bad headgasket and am tearing it apart today. We did get it running and the motor sounded good and we cut the filter open and saw no shavings or metal. Strained the oil and didnt see any metalic or...