donalloy1
New member
- 673
- 1
- 0
- Location
- Martinez Ca
Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!
Maybe my front springs are more shot than yours... I tried and tried and tried to get it out before I raised it up.I replaced the starter but never took out the driveshaft put it on a lift or used a jack didn't give me too much trouble but it was a PITA
This pull-type continuous-duty solenoid is nominally rated for 24V but works well with 12VDC at 120mA. Measures 1-1/8" square x 1" with a pair of 3/16" quick-disconnect terminals. The plunger is 1-11/16" x 1/4" dia with a slotted cotter pin hole. Working distance is 1-1/4". Has a 116 Ohm coil. Made in the USA by Guardian Electric, part #A420-065454-00.
Cute but it is just a linear actuator, not a solenoid relay so it cannot be used to replace the weak starter relay.I'm not sure where to best put this, but here it is. Something for the fabricators around here. At under $4 I might have to pick up a couple.
http://www.sciplus.com/p/GUARDIAN-ELECTRIC-1224VDC-PULL-SOLENOID_52455
View attachment 431559
Do you have refrigerant guages? If you do, a place to start would be to charge the evaporator coil to 40 degrees.Since this is a prototype, I don't know what the optimum charge of R134a will be. Regular automotive systems run at varying speeds, this one will run a 2500-3000 RPM constantly.
Yes, I have a set of R134a manifold gauges. 40 F at the evaporator during the hottest weather would be perfect.Do you have refrigerant guages? If you do, a place to start would be to charge the evaporator coil to 40 degrees.
We get it, advertisements are annoying!
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!