Tab Content
  • Stevev's Avatar
    Today, 21:45
    Stevev replied to a thread Stock horn replacement in HMMWV
    That what the boy said it’s prob almost twice as loud as stock
    13 replies | 87 view(s)
  • Stevev's Avatar
    Today, 21:09
    Stevev replied to a thread Stock horn replacement in HMMWV
    26a to the blue power wire on the horn 25a to the horn body to ground it did the trick THANK YOU SO MUCH
    13 replies | 87 view(s)
  • Stevev's Avatar
    Today, 20:47
    Stevev replied to a thread Stock horn replacement in HMMWV
    This was a cheap horn only $30 and is 350 db is there a horn you recommend? i just wanted a louder one then the mouse squeak I have now...lol
    13 replies | 87 view(s)
  • Stevev's Avatar
    Today, 20:45
    Stevev replied to a thread Stock horn replacement in HMMWV
    Both wires are labeled and i marked them so I can put the old horn back if needed
    13 replies | 87 view(s)
  • Stevev's Avatar
    Today, 20:23
    Stevev replied to a thread Stock horn replacement in HMMWV
    **** I figure it would be easy so are both wires power? i tried testing them with my meter individually and got nothing when pressing the horn...
    13 replies | 87 view(s)
  • Stevev's Avatar
    Today, 20:08
    Stevev started a thread Stock horn replacement in HMMWV
    Hey guys I ordered a new louder horn and it only has a blue power wire and the unit grounds when you bolt it in I guess the current horn has two...
    13 replies | 87 view(s)
  • Stevev's Avatar
    11-27-2019, 20:21
    Stevev replied to a thread Engine fan in HMMWV
    Let me clarify the blades don’t freewheel and when it’s idling it spins at the speed of the pulleys when the engine is cold or hot
    8 replies | 252 view(s)
  • Stevev's Avatar
    11-27-2019, 20:00
    Stevev replied to a thread Wait light Quick blink only in HMMWV
    Thanks for all the help just replace the smart start box all good now!!!
    9 replies | 271 view(s)
  • Stevev's Avatar
    11-27-2019, 19:49
    Stevev started a thread Engine fan in HMMWV
    Hey Guys Happy Thanksgiving this may be a dumb question but should I be able to turn the fan blades when the engine is off? blades donít spin...
    8 replies | 252 view(s)
  • Stevev's Avatar
    11-24-2019, 10:13
    Stevev replied to a thread Oil pressure spike in HMMWV
    Thanks for the advice I’ll start by first checking all connections and I will take out and clean the sending unit
    7 replies | 144 view(s)
  • Stevev's Avatar
    11-24-2019, 09:41
    Stevev replied to a thread Oil pressure spike in HMMWV
    Thanks for the help not sure what gauge’s to get What do you recommend a mechanical gauge is there one that will fit in the current holes in...
    7 replies | 144 view(s)
  • Stevev's Avatar
    11-23-2019, 19:10
    Stevev started a thread Oil pressure spike in HMMWV
    Out and about today notice my oil pressure at 90psi when it usually runs 50-60 little higher when engine is cold if I start to unscrew wire on...
    7 replies | 144 view(s)
  • Stevev's Avatar
    11-20-2019, 19:39
    Stevev replied to a thread Wait light Quick blink only in HMMWV
    Thank you for the help I ordered a new tsu with the yellow band that matches the one in my truck Iím so hoping that does the trick everything...
    9 replies | 271 view(s)
  • Stevev's Avatar
    11-20-2019, 10:36
    Stevev replied to a thread Wait light Quick blink only in HMMWV
    Thank you very much for the help I found a post that shows how to run new glow plug wires and bypass the controller with an external bottom ...
    9 replies | 271 view(s)
  • Stevev's Avatar
    11-19-2019, 19:00
    Stevev replied to a thread Wait light Quick blink only in HMMWV
    Just unplugged my tsu and replugged it in same problem I check the ohms at the glow plugs got 2.9-3.1 tested to see if I have power at the plug...
    9 replies | 271 view(s)
  • Stevev's Avatar
    11-19-2019, 13:03
    Stevev replied to a thread Wait light Quick blink only in HMMWV
    Thanks bud I will try that when I get home if it still does the quick blink should I order a new tsu could it be bad one other thing I found...
    9 replies | 271 view(s)
  • Stevev's Avatar
    11-19-2019, 10:42
    Good morning im new to this sight but have found it to be a great help thanks for all the info and posts I have a 1989 m988 my voltage reg went...
    9 replies | 271 view(s)
No More Results
About Stevev

Basic Information

Date of Birth
June 24, 1973 (46)
About Stevev
Location:
Dover nh

Statistics


Total Posts
Total Posts
17
Posts Per Day
0.29
Total Thanks
Total Thanks
0
General Information
Last Activity
Today 21:45
Join Date
10-08-2019
Referrals
0
iTrader Profile Recent Ratings
Feedback Score:
Positive Feedback:
0
0%
Members who left positive:
Members who left negative:
0
0
Total positive feedback: 0
Submit Feedback For Stevev
View Complete Feedbacks for Stevev
  Past
Month
Past
6 Months
Past
12 Months
  0 0 0
  0 0 0
  0 0 0