Recent content by 1968 Kaiser M35A2

Hello All! I did my homework and read on here for a few hours before I decided to post my question. I recently had the good fortune to salvage some parts off of a M543A2W Wrecker (do not know why the 3 is in there). The pump is a Ross HF64-R. Has anyone had any luck with this model installing on...

Here is a picture of a cooling filter in an M54 that I salvaged. I plan on putting in in my M35 the same way.

I used a set of 5 ton springs for my bobbed project. So far so good. Any info you need that may help?

I gotta say alot of you say how she doen't look to bad. Well consider her like that girl you see at 50 yards and shes walking toward you and as she get closer you think, "Holy catfish" my impure thoughts just got ruined. Well as you get closer to the truck you can see she is a rust bucket. I am...

I late following up on this but I just got back from vacation. I did not get the steering arm from the M54 and I had to use a hot wrench to get the ps ram out. I just took the reservior, ram and pump. So the question is, how does this work if it is not connected anyway to the steering box? Is it...

Although she is not something you would restore do to all the rot I did get some good upgrades for mine. Main items are an air shift TC, heater and a good drivers seat frame with springs and shock. Started parting her out yesterday. I do not know who put runs on her side but she don't. There was...

Howdy all. I sent an earlier post back in Jan but never got any responses. I am about to install hydraulic assist. Has anyone done what I asked in the post before this one? I would appreciate the imput. Many thanks, Griff

Speddmon, I know what you mean after reading TM's and scematics. So for simplicitys sake what would help my piece of mind would be this. I have a 1986 White multifuel MSR located on the right side covered by the air filter. I imagine that this is normal locationfor this engine. Question, what...

Thanks Bjorn. I imagine I can figure it out. My problem is that I do not have wire No. 10 on the bottom post of my MSR. I do not have wire 10 at all. But if C (ground) post on MSR represents the small post on top that has nothing connected to it and A post is the 3/8" post directly below C and...

When I went to start my Deuce for the first time it didn't. I traced the wires and found that the two wires from the solenoid to the magnetic start relay were disconnected. I have a different set up than what shows on the wiring scematic (less wires) so I just want to make sure. So in a...

Here is the start of my project. Got the 5 tons springs installed. Now at least I can move her around easier. I must say she sure is narrow in the hips until I flip those hubs. Instead of poker night, I have deuce night every Tuesday.

I am actually doing the same thing with the hemmt wheels I picked up. I going to knock out all the studs from the rim and will drive them through the 1/2" adapter plate that I am having water jet cut. After cutting I will bevel the holes for the lugs on the drill press. The water jet will also...

Can anyone tell me what this transfer case goes into? It is an Arvinmeritor T-2119. Thanks for your help. Griff

Just figure out how to mount a brush hog or plow. Now you have a farm implement to go with those toe maters.

I have not done the reaserch on specs. My cost was free. Here is a pic of the way they orginally had the hydraulic assist ram on the M54. I figured why cant I use the same belt driven pump and reservoir and just clamp the ram to the tie-rod. Anybody ever do that?