Recent content by 760gamemaster

IN

The doghead relay mod should take care of it then.

Where is this magnetic switch?

Changed all 3 belts.

Chilly about 25 degrees. I have cut the wire from the resistor and run the glow plug relay to the 12 volt block I to thought that to be the problem since my wait light was being funky also but I installed an Antenna Climber card and now the wait light works right but maybe the gp relay is going...

My problem is a little different Just after startup my Gen2 light will flicker and the voltmeter jump down and up and I hear a rapid clicking from the dash. It the goes away and works and charges normally even for hours if driven. Usual checks good I suspect the relay but would the light not...

Installed an Antenna Climber card works great!

Same symptoms intermittent surging stalling hard starts will run great a few days then do it again. Changed filter bled and a leaking fuel line fixed pulled check valve no chunks a little varnish cleaned looks good . Where do I look next?

Every day to work the 1028 is my main vehicle.

Great work as always!

This where I really like liquid electrical tape cover every thing bare with a couple coats and let dry before you reconnect the batteries and is good to go and easy to.

Me to same thing replaced relay no problems.

Dude you must work at "The Mill' the CUCV1028 is mine and the bobbed Duece belongs to an employee in the Silicon Dept stop on over at the union office and visit me.

Welcome from just up the road.

My relay also failed a few days after the bypass changed it and everythings great now.