Recent content by 79 oshkosh 2323

No need to P/M just post the pictures

What town are you in.. Post some pictures. Sorry so slow at getting back to you. Whats there condition.

Ok… what do you have.

looking to swap my M715 for a nice M37 with winch. Must have a V8 GM or Mopar Engine. My m715 is a rust free cab hardtop , 6BT cummins with 100,000 miles with auto trans.. still needs to be wired and master cylnder installed bed was purchased from another truck has a small amount of rust.. new...

Im not really sure.. it has the transfer case right on the transmission. Its not divorced..

well i was actually wondering about the adaptor. Pictures are so people would know what it came from . If i put it in the wrong area i will change it

6 cylinder chevy trans adaptor for anybody swapping out . Have engine mounts as well. Are they available .. i think i may have one in a jeep gladiator i purchased for the grill. If i am wrong please correct me.. this is what i was told

Found them .. summet racing have them. spacers available as well.. thanks guys.. this is worth a shot. Short money as well

wow.. i bet that would work. Wonder where i would get one..that would defenitly work.. thank all for the responses

I dont know if i could enlarge the hole in the center to go over the threaded part.. i think by the time the hole is cut big enough you would be into the 4 bolt holes

I would like to get a clutch fan on it.. thank you

I didn’t know the housing had bolts to bolt a fan to. I thought it was just the threaded piece for the clutch.. i will look into that. Thanks

I got this project the way it is. It Already had the engine in it.. IM trying to finish it over time or swap for a converted M37 with V8. Engine but no one has been interested to trade.. . It runs very very well.. i have always favored the M37 but this came along and was hard to pass it up.

There is no room between the engine and radiator for the stock fan.. most people who have done this swap use a electric fan.. I didn’t do the swap i purchased it un finished..

I was wondering what to put on for an electric fan. There is no room for the clutch fan on the motor.. I would like to go the biggest i can go.. any suggestions, pusher or puller fans and what CFM.. Thanks