Recent content by ajallow80

ok will take a look at those items. thanks again.

ok will take a look thank you and I'm just going to replace the whole thing.

sorry i guess my question is what is the BIG AUCTION SITE? do you have a link? thank you.

I need a voltage regulator for my MEP006a too. You mentioned there is one available on the BIG AUCTION SITE?

Got it switched back to 3 phase 416v thank you for all your help.

The above snapshots are from the TM manual for the MEP006A. The third pic shows the correct configuration for the three phase (at least that's what I think). The rest of the pics is what I used to determine the wiring.

yes it seems like a few at least one of the wires is in the wrong place based on what I was able to find form the manual. looks like the wire numbers you referenced above a different for the MEP006A except for the third one. Below is how i think it should be wired. X7E16A connects to TB6-7...

got it thanks.

Ok I'll see if I can figure that out, I suck at reading wiring diagrams :). Also when you say regulator, you referring to the voltage regulator correct? thanks again.

some pics of the back after replacing the cut copper back and removing the jumper

Here is the current configuration of the reconnection board. I suppose I need to shift it up vertically so that the number 4 lines up with the arrow for 240/416 correct?